Fisher-Price GeoTrax K3116 User manual

Troubleshooting
SYMPTOM SOLUTION
Battery power in the engine may be weak. Replace all three batteries
in the engine with fresh, alkaline batteries.
The wheels on the engine or attached cars may be dirty.
Wipe them with a clean cloth.
Battery power in the remote controller may be weak. Replace all
three batteries in the remote controller with fresh, alkaline batteries.
You may be beyond the maximum range of the remote controller
which is about 12 feet.
You may not have a clear path between the remote controller and
the engine. This toy works best when there are no obstructions
between the engine and the remote controller.
Bright sunlight or fluorescent lights may affect the range of the remote
controller. Try dimming the room you are playing in.
The engine may have shut off. If you do not operate the remote
controller for a few minutes, the engine shuts off automatically and
the ready light turns off. Press the power button on the engine, and
operate the remote controller to restart.
Engine does not
respond to the
remote controller
Engine drives slowly
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user's authority to operate the equipment.
FCC Note (United States Only)
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. PRINTED IN CHINA
©2005 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. K3116pr-0920
Visit us on line at www.service.fisher-price.com.
Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers
using TTY/TDD equipment, please call 1-800-382-7470.
Write to us at: Fisher-Price® Consumer Relations,
636 Girard Avenue, East Aurora, New York 14052.
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required for battery installation.
Tool required for battery installation: Phillips screwdriver
(not included).
Wipe the toy with a clean damp cloth. Do not immerse.
For other countries outside the United States:
Canada: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303. www.service.mattel.com/uk.
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Visit www.fisher-price.com
to see the entire world of
GeoTrax® accessories!
K3116
www.fisher-price.com

Toot!
Toot!
Toot!
Toot!
Rhhhh!
Rhhhh!
Your child is bound for
a world of adventure!
READY
LIGHT
POWER
BUTTON
Battery Installation
Train Engine
• Locate the battery compartment on the
back of the train engine.
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Lift the battery compartment
door and insert three “AAA” (LR03)
alkaline batteries.
• Close the battery compartment door
and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
Battery
Information
Remote Controller
•
Locate the battery compartment on the side
of the remote controller.
• Loosen the screw in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door and insert three
“AAA” (LR03) alkaline batteries.
• Replace the battery compartment door and
tighten the screw with a Phillips screwdriver.
Do not over-tighten.
1.5V x 6
“AAA” (LR03) Your child is bound for
a world of adventure!
SHOWN ACTUAL SIZE
We recommend the use of alkaline batteries
for longer battery life.
IMPORTANT! Under normal use conditions, the batteries in the engine will require
replacement more often than the batteries in the remote controller. For additional
information, see the troubleshooting section.
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the toy. Dispose of batteries
safely. Do not dispose of product in a fire.
The batteries inside inside may explode
or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
toy before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn
injury or ruin your toy. To avoid battery leakage:
All Aboard!
OFF
FORWARD
FORWARD
(With Sound Effects)
1
2
3
1
2
3
3-Position Remote Controller
To prevent entanglement,
keep hair away from wheels.
WARNING
The more you
collect, the more
fun it gets!
Multiple track packs used to create this configuration.
Each sold separately & subject to availability.
Use multiple
remote control
vehicles
at once!
Woo-
Wooooo!
Woo-
Wooooo!
Additional track sold separately and subject to availability.
•
Hook the cars together and place them
on the track. Make sure the engine is
in front.
Hint: We do not recommend using the
engine on carpets. For best performance,
use on the track provided or hard,
flat surfaces.
• Press the power button on top of the
engine. The ready light turns on.
• Hold the remote controller with the
stick facing you. Point the remote
controller toward the engine and
push the stick forward. The engine
moves forward around the track.
• To stop the engine, pull the stick
backwards to the stop position.
Hints:
• If you do not operate the remote
controller for a few minutes, the
engine shuts off and the ready
light turns off. Press the engine
power button, and operate the
remote controller to restart.
• This toy works best if you have a
clear path between the remote
controller and the engine. Point
the remote controller at the engine.
The maximum range of the remote
controller is about 12 feet.