Fisher-Price Rescue Heroes Mission Select Rescue Jet User manual

w
w
w
.r
e
s
cu
e
h
e
r
o
e
s
.
c
o
m
Model Number: B5733
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tool required for battery installation:
Phillips screwdriver (not included).
Requires three “AA” (LR6) alkaline batteries (not included).
Rescue Jet
Figure sold separately and subject to availability.

2
PARTS
Label Sheet (Not Shown)
Body
2 Rear Wheels
Tail Wing
Tail Wing
Canopy
Nose
Tabs Tail
Openings
Rear Wheels
•Turn the jet upside-down, and place it on a flat surface.
•Position the rear wheels so that the tabs are toward the nose of the jet.
•Insert and “snap” the plug on the rear wheels into the openings near the tail of
the jet.
ASSEMBLY

ASSEMBLY
3
Tail Slots
Tabs
Tail Wing
Canopy
Pegs
Holes
•Position the jet upright.
•Insert and “snap” the tail wing tabs into the slots in the tail of the jet.
•Insert and “snap” the pegs on the canopy into the holes in the cockpit.
DECORATION
Proper label application will help to keep the labels looking their best!
•Make sure the areas where the labels will be applied are clean and dry. Wipe this toy
with a clean, soft, dry cloth to remove any dust or oils.
•For best results, do not attempt to apply a label more than once.
•Apply the labels as shown in the illustrations.
7
15
Right Side View

Left Side View
4
DECORATION
614
2
13
12
1
4
811
4
9
10
3
Top View
5
Rescue Pack

BATTERY INSTALLATION
5
1.5V x 3
“AA” (LR6)
SHOWN ACTUAL SIZE
Hint: We recommend the use of alkaline batteries for longer battery life!
Bottom View
Battery Compartment
•Loosen the screw in the battery compartment door with a Phillips screwdriver and
remove the battery compartment door.
•Insert three “AA” (LR6) alkaline batteries.
• Replace the battery compartment door and tighten the screw with a Phillips screw-
driver. Do not over-tighten.
•When lights or sounds from this toy become faint or stop, it’s time for an adult to
change the batteries!
Battery Safety Information
Batteries may leak fluids that can cause a chemical burn injury or ruin your toy. To
avoid battery leakage:
•Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
•Insert batteries as indicated inside the battery compartment.
•Remove batteries during long periods of non-use. Always remove exhausted batteries
from the toy (product). Dispose of batteries safely. Do not dispose of batteries in a
fire. The batteries may explode or leak.
•Never short-circuit the battery terminals.
•Use only batteries of the same or equivalent type, as recommended.
•Do not charge non-rechargeable batteries.
•Remove rechargeable batteries from the toy (product) before charging.
•If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.

TO THE RESCUE
6
Hint: Bring this air rescue mission to life with a Voice Tech™Rescue Heroes™figure
(sold separately).
Groove Mission Dial Connector
Mission Select™Billy Blazes™
sold separately.
•Remove the backpack from your
Mission Select™Rescue Heroes™figure.
(sold separately)
•Slide the connector on the back of the figure into
the groove in the seat back in the jet cockpit.
•Turn the mission dial near the back of the jet to
select a mission.
•Press the talk button to hear the figure talk about
the mission.
Hint: If a Mission Select™Rescue Heroes™figure is not fully inserted into the cockpit, press-
ing the talk button on the top of the jet will result only in jet engine sounds and lights.
Talk Button Mission
Dial
•Lower the handle to guide “flights”.
•Press the button near the handle for jet engine sounds and lights!
Handle
Button

TO THE RESCUE
7
Rescue
Hook
Rescue Pack
Sound Switch
•Fit the rescue pack onto the back of the figure.
•Lower the rescue hook to start sounds and lights.
•Lift the figure using the rescue hook for sound and lights!
Hint: There is a sound switch on the rescue hook!
Groove
Connector
Note: Rescue Heroes™ figures sold separately.
STORAGE
•Fit the backpack to the connector on the underside of either wing.
Backpack Connector
Connector

•Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do
not immerse this toy.
•This toy has no consumer serviceable parts. Do not take this toy apart.
Questions? We'd like to hear from you!
Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437, 8 AM - 6 PM EST
Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment, please
call 1-800-382-7470. Or, write to: Fisher-Price® Consumer Relations, 636 Girard Avenue,
East Aurora, New York 14052.
For countries outside the United States:
CANADA Questions? 1-800-567-7724. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga,
Ontario L5R 3W2.
GREAT BRITAIN Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500302.
AUSTRALIA Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria
3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. Printed in China
©2003 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. B5733pr-0920
CARE
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible
for compliance could void the user’s authority to operate the equipment.
FCC NOTE (UNITED STATES ONLY)
CONSUMER INFORMATION