Fisher-Price W9740 User manual

1
Please keep this instruction sheet for future reference, as it contains important information.
For ages 9 – 36 months and up to 44 lbs (20 kg).
Adult supervision is required.
Never use near steps.
Choose areas for riding that are free of obstacles.
Learn to stop safely.
Use with caution as this product requires skill to operate safely to avoid falls, collisions,
and injuries to yourself (the rider) and others.
Requires three AA batteries (included) for operation. Batteries included are for demonstration purposes only.
Adult assembly is required. Tool required for assembly: Phillips screwdriver (not included).
W9740
BMG86
fisher-price.com
Sit
Walk
Ride
Ride

2
Frame
Frame
This package contains small parts.
For adult assembly only.
CAUTION
Puppy
• Fit the frame to the puppy.
• While holding the puppy in place, carefully turn the
assembly over.
• Insert three screws into the frame and tighten.
Assembly
Puppy
Handle
Assembled Parts
2 Hubs
2 Rear Wheels
#8 x 1¼" (3,18 cm) Screws – 7
Shown Actual Size
Note: Tighten and loosen all screws with a Phillips
screwdriver. Do not over-tighten screws.
1
2

3
Assembly
Handle
Rear Wheel
• Carefully turn the assembly upright.
• Press the bar under the back of the seat and lift the seat.
• Insert two screws into the top of the frame and tighten.
•
Insert two screws into the top of the frame and tighten
.
H
andle
• Press the bar on the bottom of the seat and lower the seat.
• Insert and "snap" the handle into the sockets in the seat.
• Fit a rear wheel onto the peg on one of the back legs.
PRESS
PRESS
PRESS
PRESS
3 5
6
4

4
Assembly
Hub
• Fit a hub into the center of the rear wheel.
• Insert a screw into the center of the hub and tighten.
• Repeat this procedure to assemble the other rear wheel, hub
and remaining screw.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Dispose of batteries
safely. Do not dispose of the product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to
be charged under adult supervision.
1,5V x 3
AA (LR6)
• For longer life, use alkaline batteries.
• Locate the battery compartment on the back of the
puppy's head.
• Lift the seat to access the battery compartment.
• Loosen the screws in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment door.
• Insert three AA (LR6) alkaline batteries.
• Replace the battery compartment door and tighten the screws.
• If this product begins to operate erratically, you may need to
reset the electronics. Slide the power/volume switch off and
then back on.
• When sounds or lights become faint or stop, it’s time for an
adult to change the batteries.
Battery Replacement
8
7
• Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check
your local authority for recycling advice and facilities.

5
• Slide the power/mode switch to: Learning , Music
or Imagination mode.
Learning - Press the shape buttons to learn shapes and
colors or hear a song. Press the puppy's nose or open
and close puppy's mouth to hear phrases. Listen to songs
when you roll the puppy!
Music - Press the shape buttons to hear fun sounds.
Press puppy's nose, open puppy's mouth or roll the
puppy to hear fun songs!
Imagination - Press the shape buttons, press puppy's nose,
open puppy's mouth or roll the puppy for sounds and phrases!
• Slide the volume switch to low or high volume.
• When you are finished playing with this toy, slide the
power/mode switch OFF .
Convert to Walker
• Press the bar under the back of the seat and lift it until it
"snaps" in place as a handle.
• Push the handle to be sure it is secure.
Convert to Rider
• Press the bar on the bottom of the handle and lower it as
a seat.
Rewarding Music & Lights!
Walker
Walker
Ride-On
Ride-On
PRESS
PRESS
PRESS
PRESS

6
Care
• Wipe with a clean cloth dampened with a mild soap and water
solution. Do not immerse.
• Periodically inspect this product for wear or damage. Check
all nuts and bolts, and tighten as needed. Replace worn or
broken parts immediately.
©2013 Mattel. All Rights Reserved.
PRINTED IN MEXICO W9740c-0920
Consumer Information
FCC Statement (United States Only)
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment. This device complies with
Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
ICES-003
This Class B digital apparatus complies with Canadian ICES-003.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NMB-003
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada. L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre le fonctionnement
du dispositif.
CO
N
SU
MER A
SS
I
S
TAN
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.