Fisher-Price Y6599 User manual

Y6599
Y6599
fisher-price.com
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three AA (LR6) alkaline batteries (not included) for operation.
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
1
2
3
4

2
©2013 Mattel. All Rights Reserved.
PRINTED IN CHINA Y6599pr-0920
Consumer Information
FCC Statement (United States Only)
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications
not expressly approved by the
manufacturer responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
ICES-003
This Class B digital apparatus complies
with Canadian ICES-003. Operation is
subject to the following two conditions:
(1) this device may not cause harmful
interference and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
NMB-003
Cet appareil numérique de la classe B
est conforme à la norme NMB-003 du
Canada. L’utilisation de ce dispositif
est autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même
si ce brouillage est susceptible de
compromettre le fonctionnement
du dispositif.
CO
N
SU
MER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.

3
Consumer Information
Prevent Entanglement Injury
Crib Mobile Use
• Keep out of baby's reach.
• Remove mobile from crib or playpen when baby begins to
push up on hands and knees.
• This product may not attach to all crib designs. Do not add
additional strings or straps to attach to a crib or playpen.
Stroller Toy Use
• Do not attach link directly to crib or playpen.
• Use as a mobile from birth until 5 months.
• A mobile is intended for visual stimulation and not to be grasped by a child.
• Wipe this toy with a clean, damp cloth. Do not immerse this toy.
WARNING

4
Assembled Parts
Mobile
Mobile Link
3 Removable Toys Crib Mobile Arm
Soother
C
rib Mobile Ar
m

5
Crib Mobile Assembly
Crib Mobile Arm
Soother Socket
1
• Slide the door open on the top of the soother A.
• Fit the mobile arm into the socket in the top of the soother B.
• Tighten the permanent screw inside the mobile arm C. Pull up on the mobile
arm to be sure it is secure.
AB
C

6
2
• Fit the mobile link peg into the top of the mobile. Push to "snap" in place.
• Fit the ends of the mobile link onto the mobile arm. Push to “snap” the link
in place.
2
Mobile Link
Mobile
3
• Fit the ends of the straps on the mobile into the slot in each toy.
• Pull down on each toy to be sure it is secure.
Hint: The toys are removable for take-along fun! Push to remove the end of the
strap from the slot on the toy.
Crib Mobile Assembly

7
Soother Battery Installation
• Loosen the screws in the battery compartment door and remove the door.
• Insert three AA (LR6) alkaline batteries.
• Replace the battery compartment door and tighten the screws. Do not over-tighten.
• If this toy begins to operate erratically, you may need to reset the electronics.
Slide the power/mode switch off and back on.
• When sounds become faint or stop, it's time for an adult to change the batteries.
• Protect the environment by not disposing of this product with household
waste (2002/96/EC). Check your local authority for recycling advice
and facilities.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted
batteries from the product. Dispose of batteries safely. Do not dispose of this
product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
1,5V x 3
AA (LR6)
For longer life, use
alkaline batteries.

8
Crib Mobile/Soother Attachment
IMPORTANT! Always attach all provided fasteners (strings, straps, clamps, etc.)
tightly to a crib or playpen according to the instructions. Do not add additional
strings or straps to attach to a crib. Check frequently.
Crib Rail
Attachment Strap
Attachment Strap
1
A
B
D
C
• Position the toy inside the crib. Make sure the attachment strap is on the outside
of the crib A.
• Slide the end of the attachment strap down through the slot on the back of
the toy B.
• Pull the end of the attachment strap up and fasten to the peg on the back of
the toy C.
Note: This toy should be snug against the crib rail and spindles. Use the strap slot
that provides the tightest fit.
• If you have excess strap, slide the free end of the attachment strap up through
the opening near the top of the attachment strap D.

9
Crib Mobile/Soother Attachment
• Make sure the distance between the bottom of the soother and the crib
mattress is at least 7 inches (18 cm).
• If the distance is less than 7 inches (18 cm): readjust the attachment straps to
lift the toy; or lower the crib mattress.
Mattress
Mattress
Bottom of Soother
Bottom of Soother
At Least 7 Inches (18 cm)
At Least 7 Inches (18 cm)
• Tie the toy’s strings to a crib spindle.
Note: It is better to tie the strings in a knot than a bow, since a bow may be
easily untied.
2
3

10
1Musical Crib Mobile
• Slide the power/mode switch to Heartbeat Sounds, Music or OFF.
• Press the button for music/sounds.
• Music/heartbeat sounds play for approximately 15 minutes. Slide the power/
mode switch off and back on to restart.
• Turn the dial on the back of the mobile link clockwise to watch the mobile spin.
Do not over-wind the dial.