Front Runner SSDR003 User manual

1
-
MERCEDES BENZ GELÄNDEWAGEN
DRAWER SYSTEM
SSDR003
INSTALL TIME: 30 mins
REV_A01
Fit Drawer SYSTEM
You will need:
9 mm Drill Bit and Drill Machine
13 mm Flat and Socket Wrench
7 mm Flat or Socket Wrench
8 mm Flat or Socket Wrench
3 mm Hex Key
4 mm Hex Key
Marking Pen
Fit the four Mounting
Brackets, two left and two
right. There are two different
height options available
when mounting the
Brackets. Choose the option
best suited to your vehicle.
()
A Place the Drawer System into the vehicle locating it as
far back as possible without it interfering with Rear Door.
Center the Drawer System left to right.
()
b
()
C Using the Mounting Brackets as
guides, mark the position of the
four Mounting Holes (Outer hole
on each Mounting Bracket) onto
the vehicle's wheel arches.
Remove the Drawer System and
drill 9mm holes through the
wheel arches on your markings.
Refit the Drawer System.

2
REV_A01
Fit Drawer SYSTEM cont...
Loosen and remove both the left and
right wheel arch liners.
()
D
(F)
INSTALL OTHER VEHICLE AND RACK ACCESSORIES
Now's the time to visit your favorite Front Runner dealer in person or online.
()
A
Secure the Drawer System to the vehicle using
the four M8x70 Hex Bolts, Large Body Washers,
M8 Flat Washers and Nyloc Nuts supplied. Both
Washers are used on the underside of the
vehicle.
()
E
Refit the two wheel arch liners and complete the installation, by fitting the two Front Cover Panels and
Deck Side Skirts.
Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!