FrontLine X27 User manual

X27 System Components
WARNING!
DO NOT force the connectors together!
WARNING!
Illuminating the lights when rolled may
result in damage to the lights!
• Hanging Strap
• Control System
• Power Cable
• LED Lighting
• Power Supply
“Y” Cable (Optional)
• Locking Connectors
• Multi Line
STEP 1 - MAIN POWER
Standard Barracks
Examples: NOTE some configurations may require a “Y” cable
Multiline
• Verify shelter's power provides 100-140- VAC
• Check for damage or loose connections that may have occured during shipping
or storage
• The location of the control system should be near the main entrance next to
the power distribution box
• Connect the systems power cable to the shelter power (shore power) and hang
the sling on the shelter wall
The connectors are keyed to align the positive and negative terminals.
Damage to the connectors may result!
STEP 2 - PREPARING YOUR LIGHTS
• Remove the lights from the sling system
• Unfurl the lights before illuminating
• To adjust the hanging system see “STEP 3 - Adjusting the hanging system”

STEP 3 - HANGING THE X27 SYSTEM
• Multiple hanging methods are available from the Frontline website
• The lighting configuration should be supported every 5 feet
• Zipties, tape, velcro strapping or rope can be used to hang the system
STEP 4 - EXTENDING THE X27 SYSTEM WITH A “Y” CABLE
• 40 feet (12 meters) of light can be powered on each line
• Multiple lights can be powered at the same time using our “Y” cable
• Use of a “Y” cable will power up to 80 feet (24 meters) of light.
STEP 5 - STORAGE
• The X27 can be coiled and stored like a typical exten-
sion cord and then strapped into the harness using the
integrated velcro straps
• Use the main buckles to collapse and tighten the
system
• Once main buckles are connected it can be slung over
the shoulder or affixed to equipment to bring or
remove from site
LIGHTING REPAIR
• Installation video is availble online
• Downloadable manual is also available
• Visit www.frontlinelighting.com or scan the QR code
TROUBLESHOOTING
If, after checking the above, the system is still not
operating as desired. Please contact Frontline
Lighting for direct assistance.
www.frontlinelighting.com
Contiguous configuration: Up to 40ft
Split configuration: Multiple lines totalling 80 ft
Lights not operating
• Ensure main power is active and connected
• Check plugs and connections are firmly in place and connected
• Examine connections for loose pins or exposed wires
• Check power switch is in the “ON” position
• If battery is being used, make sure battery is charged and properly connected
Sections of lights are not operating
• Repair kits can be purchased from Frontline Lighting
• Replacement flex lengths can be purchased
Lights are flickering
• Too many lights lengths of light may have been connected
• Utilize “Y” connection cable to split the light lengths
Control system not operating
• Ensure main power is on and connected
• Visually examine connections for loose pins or exposed wires
• Check power switch is in the “ON” position
Lights are twisting
• Turn lights on for a short perod of time and then re-align the LED’s to face in
the desired direction.
• Increase the amount of hanging points being used
Power supply is becoming hot
• Contact Frontline Lighting
Components are damaged or missing
• Contact Frontline Lighting