Furniture of America CM7949HB-FQ User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM7949HB-FQ
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-03-28
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
Wrench
(Included)
Phillips Screwdriver (Not Included)

Page 2 of 5

Parts List
#1 x 1 pc
Headboard
#2 x 2 pcs
Leg
#E x 4 pcs
Hex Nut
#F x 1 pc
Flat Wrench
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#G x 1 pc
Allen Wrench
MD
#H x 2 pcs
Anchor
Page 3 of 5
#I x 2 pcs
Screw
#J x 2 pcs
Flat Washer
Hardware List (Continued)
Hardware List
#A x 8 pcs
Bolt 5/16”x1-1/2”
#B x 4 pcs
Bolt 5/16”x2-1/4”
#C x 16 pcs
Lock Washer
#D x 16 pcs
Flat Washer

Turn right (clockwise) to tighten
Page 4 of 5
#A x 8 pcs
#C x 8 pcs
#D x 8 pcs
Open Velcro to remove legs and hardware
pack from behind the headboard (#1).
I. Align the legs (#2) with the pre-
drilled holes on the back of the
headboard (#1).
II. Prepare 8 bolt assemblies by
inserting FIRST the lock
washer (#C) onto the bolt (#A)
and then the flat washer (#D)
onto the SAME bolt (#A), in
that order.
III. Insert the bolt assemblies
through the legs (#2) and
secure those bolts using the
Allen wrench (#G) to lock them
in with the headboard (#1).
.
#1
#1
#2
#2

Turn right (clockwise) to tighten
OPTIONAL WALL MOUNT
Page 5 of 5
#B x 4 pcs
#C x 8 pcs
#D x 8 pcs
#E x 4 pcs
ASSEMBLY IS COMPLETED
This is an optional step to assemble the headboard onto the bed
frame (sold separately). Align the holes of the completed
headboard with the holes of the bed frame. Insert the bolts and
washers according to diagram below. Use the supplied tools to
secure those parts.
I. Wall Mount (No Stud): Select a location where
you want to the headboard to be mounted. Mark
on the wall the two locations where the wall
anchors (#H) will be placed. Drill a hole for each
anchor slightly smaller then the size of the screw.
Push the anchor (#H) as far as it will go with your
finger. Tap gently with a hammer until the wall
anchor (#H) is flush with the wall surface. Align
the headboard (#1) with the anchors (#H). Insert
the screws (#I) with the flat washers (#J) into the
legs (#2) and tighten those screws using a
Phillips screwdriver to lock them down with the
anchors (#H).
II. Wall Mount to Stud: Repeat the process above
using only the screws (#I) and flat washers (#J)
but WITHOUT the anchors (#H).