FURNITUREBOX ELLWOOD User manual

ELLWOOD
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/ellwood-chair
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
45 MINUTE
BUILD
MAXIMUM
CAPACITY 130Kg

Follow us on Instagram
@furniturebox_uk
STEP 2
Attach lifting
mechanism [F] to the
bottom of the seat base
[B]. Use 4x washers [L]
followed by 4x bolts [H]
and tighten with Allen
key [K].
STEP 1
Use a clean, at, soft
surface to avoid any
bumps or scratches.
Attach the castor
wheels [G] to each of
the 5 leg spokes on base
[E] - these should pop
into place. Then place
hydraulic lift [D] into the
hollow within the legs
base [C] (the thicker end
of the hydraulic lift goes
into the legs base).

www.furniturebox.co.uk
STEP 3
Carefully ensure your seat
legs are upright, and then
lower the seat onto the top
of the hydraulic lift. Your
weight, when you sit on it,
will ensure the seat and legs
remain securely connected.
STEP 4
Attach the 2x arms [C]
to the seat base [B]. Use
2x bolts [H] per arm and
tighten with Allen key
[K].
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk
STEP 5
Attach the seat back [A] to
the seat base and arms using
2x bolts [I] on either side.
STEP 6
ATTENTION: Cover all
exposed bolt heads with
the covers [J] - x4 on
either side. Check overall
stability. Your chair is
now ready to use.
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk
www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.