FURNITUREBOX OXFORD OAK User manual

OXFORD OAK
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/oxford-oak
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
45 MINUTE
BUILD

Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clear, at, soft surface to avoid
bumps or scratches. Place the table top
[1] on the oor with the holes facing up.
Screw 4 x rods [A] into the holes and add
4x wooden dowels [C].
STEP 2
Place the 4 x table legs [2] over
the rods.

www.furniturebox.co.uk
FULL ASSEMBLY INSTRUCTIONS
STEP 3
Connect the 2x short
cross rails [3] to the
long cross rail [4] by
inserting 1x rod [B] and
2x wooden dowels [C}
to either side of the
long cross rail, and
slotting the short cross
rail pieces onto these.
Secure with U-Washer
[F] followed by at
washer [D] and nut [E]
on both sides, through
the holes in the short
cross rails. Tighten with
wrench [G]
STEP 4
Insert 1 x wooden dowel [C]
into the bottom of each table
leg. Attach the table base to
the table legs and secure the
long rods through the legs to
the base using 1x at washer
[D] followed by 1x nut [E] on
each leg. Tighten with spanner
[H].

STEP 5
Carefully, and with help,
turn your completed
table over so it’s now
the correct way up.
Ensure stability.
STEP 4
Slot the pre-assembled
stools into the gaps
between the table legs.

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.