FURNITUREBOX TUSCANY User manual

TUSCANY TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/tuscany
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
30 MINUTE
BUILD

Follow us on Instagram
@furniturebox_uk
STEP 2
Install the table sides 2 on the
Attach the second leg to the
other side of the tabletop via
the 3 holes, using 1 x washer
[B] followed by 1 x screw [A] per
hole, and tighten everything
with Allen key [C].
Add 3 x non-slip pads [D] to the
bottom of each leg.
STEP 1
Use a clear, at, soft surface to avoid
bumps or scratches.
Place tabletop [1] upside down on your
at, soft surface. Attach 1x leg via the
3 holes, using 1 x washer [B] followed
by 1 x screw [A] per hole, and tighten
everything with Allen key [C].

www.furniturebox.co.uk
STEP 3
ATTENTION: Carefully, and with
help, turn your table over so
it rests on its legs. Check for
stability. Your table is now ready
to use.
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.