FURNITUREBOX RENATO 140CM User manual

RENATO 140CM
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/renato
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from
the work area, small parts could cause
choking if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly.
In some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
45 MINUTE
BUILD
GLASS

Follow us on Instagram
@furniturebox_uk
STEP 2
Thread the two supporting small
blocks over the table rods rst,
one on each side.
Once these are on, thread on the
3 table leg blocks with chrome
bands on, chrome bands facing
towards you.
Then add the 4th table leg block
on top
STEP 1
Use a clear, at, soft surface to
avoid bumps or scratches.
Lay the table top on the oor,
with the bottom side facing
upwards.
Screw 4x table rods [A] into the
corresponding holes on the
tabletop metal frame, either
side of the extension piece, as
per diagram.
Next attach the supporting
bar [B] into the corresponding
holes on the tabletop metal
frame and secure with the 2 x
bolts [C] - 1 at either end. Use
the Allen key provided (Part D)
to tighten.

www.furniturebox.co.uk
STEP 4
ATTENTION: Check all nuts
are securely tightened and
then carefully lift the table
over on to its base (this will
require 2 people) and the
table is ready to use.
To extend, release the 4
catches on the ender edge
of the mechanism and
gently slide table panels
outwards. The middle panels
will automatically lift and
slot into place.
FULL ASSEMBLY INSTRUCTIONS
STEP 3
Once all table leg blocks
have been added, align
the table base holes over
the table rods and secure
in place.
Use 1 x washer [E] followed
by the split washer [H]
then nut [F]. Use the
spanner [G] to tighten.
Repeat for 3 other holes in
base.

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.