FURNITUREBOX SANDRO User manual

SANDRO
SIDE TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/sandro-side
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
30 MINUTE
BUILD
GLASS

Follow us on Instagram
@furniturebox_uk
STEP 2
Install the table sides 2 on the
glass tabletop 1 through the
threaded rods (A).
Insert the wooden dowel (F)
into the holes on the table sides
STEP 1
Put the pieces on a soft at surface
e.g. a carpet to avoid scratching or
bumping. Make sure that you have all
pieces and components ready to build
the table.
Install the threaded rods (A) at the
corresponding holes on the back of
the glass tabletop (1).
STEP 3
Install the bottom piece 3, use
the washer (D), screw nut(C), and
tighten it with the spanner (H).

www.furniturebox.co.uk
STEP 4
Install table feet 4, use
washer(E), screw (B), tighten
with screw driver (I).
FULL ASSEMBLY INSTRUCTIONS
STEP 5
ATTENTION: With help, turn
the table around to complete
assembly.