GABBY CALLA SCH-175008 User manual

ASSEMBLY INSTRUCTION
CALLA CHEST
SCH-175008
Component parts
A
Chest
1 pc
B
Leg
4 pcs
Hardware
C
Anti-Tip Kit
2 set
Tool required (Not Included)
D
Screwdriver
1 pc
P. 1 of 3
REV/01

Important Notes:
Lay the product gently on top of rug or soft surface then insert each leg (B) into
female insert below and turn them clockwise until tight. Then insert each adjuster
glide (C) into female insert on the bottom of each leg and turn them clockwise until
tight.
Before
Step 1
Step 2
After
P. 2 of 3
REV/01

Important Notes:
For Adjuster Glide: If the floor is uneven adjust the leveler located at the underside
of the feet, to do this lift the side that need to be elevated to provide access to the
levelers, turn the leveler until adequate contact with the floor.
For Anti-Tip Kit: Attach the brackets (C) horizontally to the back of the cabinet
using the small screws (A). Screw the remaining brackets (C) vertically 1 inch below
the brackets attached to the cabinet using the large screws (B). The large screws
(B) should be screwed into a stud in the wall. Align the brackets vertically and string
in the retention belt (D). Confirm strap is securely laced and locked.
P. 3 of 3
Step 1 (Adjuster Glide)
Step 1 (Anti-Tip Kit)
Step 2 (Adjuster Glide)
Step 2 (Anti-Tip Kit)
We hope you enjoy this Gabby purchase.
WALL
PRODUCT
REV/01