GABBY LANDRY User manual

LANDRY SIDE TABLE
ASSEMBLY INSTRUCTION
HARDWARE : TOOLS NOT INCLUDED :
Page 1 of 3
HARDWARE INCLUDE:
1. 1 -Anti Tip Kit
A. 2 -Small Screw
B. 2- Large Screw
C. 2-Bracket
D. 1-Retention Belt
1 Anti Tip Kit
1 Set
Screwdriver

LANDRY SIDE TABLE
ASSEMBLY INSTRUCTION
To remove adjustable shelves, remove screw from shelf support, then carefully lift shelves up
and out of the case.To reposition adjustable shelves, insert Stem of shelf supports into Holes
in End Panel, as shown. Rest the shelf on the shelf supports, and reinstall screws
Re-Tighten the bolts from inside of the door using Philip Screwdriver (not included). This can to be
done and check periodically to make sure the drawer pull are always tight.
Page 2 of 3
HOLE
SCREW
SCREWDRIVER
SHELF SUPPORT
STEP 1
STEP 2

LANDRY SIDE TABLE
ASSEMBLY INSTRUCTION
If the floor is uneven adjust the levelers located at the underside of the Leg, to do this lift Up
the side that need to be elevated to provide access to the levelers, turn the leveler until
adequate contact with the floor.
STEP 3
STEP 4
Attach the Brackets (C) horizontally to the top of the back of the Table using the Small Screws (A).
Screw the remaining Brackets (C) vertically 1 inch below the brackets attached to the Table
using the large screws (B). The Large Screws (B) should be screwed into a stud in the wall. Align the
Brackets vertically and string in the Retention Belt (D). Confirm Strap is securely laced and locked.
D
B
A
C
Page 3 of 3
Wall
Leveler