GABBY ALEXANDRA User manual

ALEXANDRA DRESSER
ASSEMBLY INSTRUCTION
HARDWARE :
Date: 20-12-2019 Page 1 of 3
HARDWARE INCLUDE:
A. 4 –Bolt
B. 2 –Handle
C. 2 - Anti Tip Kit
I. 4 -Small Screw
II. 4- Large Screw
III. 4-Bracket
IV. 2-Retention Belt
C. 2 Set
Anti Tip Kit
A. 4 Pcs
Bolt
(Tools Not Included)
Screwdriver
B. 2 Pcs
Handle

ALEXANDRA DRESSER
ASSEMBLY INSTRUCTION
- Install drawer handle taken from blister pack for the two top drawer.
- Re-position the acrylic handle for the nine drawer below Pre-installed at the backside of the face
drawer.
- If the floor is uneven adjust the levelers located at the underside of the Leg, to do this lift Up
the side that need to be elevated to provide access to the levelers, turn the leveler until
adequate contact with the floor.
STEP 2
Leveler
Bolt
Screwdriver
Handle
Screwdriver
Handle
Handle Bolt
Screwdriver
Bolt
STEP 1
A

Attach the Brackets (III) horizontally to the top of the back of the Dresser using the Small Screws (I).
Screw the remaining Brackets (III) vertically 1 inch below the brackets attached to the Dresser using
the large screws (II). The Large Screws (B) should be screwed into a stud in the wall. Align the
Brackets vertically and string in the Retention Belt (IV). Confirm Strap is securely laced and locked.
Page 3 of 3
STEP 3
IV
III
II
I
Wall
Page 2 of 3