GABBY CLAIRMONT User manual

HARDWARE INCLUDE :
1. 8 –washer
2. 8 –nuts
PARTS INCLUDE :
A. 1 –Top
B. 4 –Leg
CLAIRMONT CABINET
ASSEMBLY INSTRUCTION
PARTS INCLUDE :
1. 1-Cabinet Hutch
2. 1-Cabinet Base
3. 4-Adj. Shelf
HARDWARE INCLUDE :
A. 16 –Shelf Supports
B. 16 - Screw JP.
C. 4 - Allen Bolt
D. 4 - Lock Washer
E. 4 - Flat Washer
F. 1 - Allen Key
G. 2- Anti Tip Kit
I. 4- Small Screw
II. 4- Large Screw
III. 2- Bracket
IV. 2- Retention Belt PARTS:
HARDWARE:
Date: 19-11-2018 Page 1 of 5
1. 1 Set
Hutch Cabinet
3. 4 pcs
Adj. Shelf
(Tools Not Included)
Screwdriver
C. 4 Pcs
Allen Bolt
B. 16 pcs
Screw JP.
Side Shelf Base
A. 16 pcs
Shelf Supports
E. 4 Pcs
Flat Washer
2. 1 Set
Base Cabinet
D. 4 Pcs
Lock Washer
F. 1 Pc
Allen Key
G. 2 Set
Anti Tip Kit

Step
CLAIRMONT CABINET
ASSEMBLY INSTRUCTION
- Carefully unwrapped the adjustable shelves being tied at the side of the Hutch Cabinet.
- Carefully remove the wine rack from the Hutch Cabinet.
shelf on the shelf supports, and reinstall screws Page 2 of 5
STEP 1
STEP 2
STEP 2
Remove
Adjustable Shelf Right
Remove
Adjustable Shelf Left

__
CLAIRMONT CABINET
ASSEMBLY INSTRUCTION
-Carefully place the Hutch above the Base, aligning the holes for the bolts on hutch cabinet to
the insert nut of the base.
-Insert the Allen Bolt through the lock washer and flat washer and into the insert nut of the base
through the hole of the Hutch then lock with the Allen key.
-Determine the desired height for the shelves, insert the shelf supports (A) into the pre drilled
holes located in the hutch cabinet. Carefully insert the shelves as shown and gently rest the
shelves onto the angular shelf support and screw using Philip Screw driver (Not Included).
Page 3 of 5
STEP 3
F
C
D
E
Back
STEP 4

CLAIRMONT CABINET
ASSEMBLY INSTRUCTION
- To reposition the shelves, un-screw the shelves from shelf supports, then carefully lift the
shelves up and out of the case. Inserts stem of shelf supports into holes in end panel, as shown.
rest the shelf on the shelf supports, and reinstall screws.
- Carefully return back the wine rack to the hutch cabinet.
Page 4 of 5
STEP 6
STEP 5
A

CLAIRMONT CABINET
ASSEMBLY INSTRUCTION
-If the floor is uneven adjust the levelers located at the underside of the Feet, to do this lift Up
the side that need to be elevated to provide access to the levelers, turn the leveler until
adequate contact with the floor.
Attach 2 Brackets (III) horizontally to the top corners of the Unit using the Small Screws (I).
Screw the remaining Brackets (III) into the wall vertically 1 inch below the previously installed brackets
using the Large Screws (II). The Large Screws (II) should be screwed into a stud in the wall. Align the
brackets vertically and string in the Retention Belt (IV). Confirm Strap is securely laced and locked.
Page 5 of 5
STEP 7
STEP 8