Gama Sonic 101iST60822 User manual

6W SOLAR AREA LIGHT WITH
MOTION SENSING AND TIMER
*Pole not included
Model: 101iST60822
Version 1.1
Instruction Manual

Operation Switch
Timer Switch
page 2
Thank you for your purchase. GAMA SONIC
®
solar charged lights are brighter and last all night with
a full day solar charge. Unique designs, superior light output and numerous installation options
confirm the outstanding value of our product.
GAMA SONIC
®
has been recognized as a worldwide leader in the lighting industry for over 20 years.
Please read the instruction manual carefully to obtain the best results from your purchase.
Post Mounting Surface Mounting
Package Contents
*Pole not included
For technical assistance and more
information call our Toll-Free number:
800-835-4113
(only within the US)
Or visit our website or download the latest
version of your instruction manual:
www.gamasonic.com Or
www.gamasonic.com/user-guides
Operation Switch
Place the lamp in one of the two operating settings:
On: The lamp will constantly be on at 270 Lumens for the first four
hours. After that, it will be reduced to 135 Lumens and increase to 270
Lumens when motion is detected for one minute.
PIR: The lamp will remain off until motion is detected after Dusk.
When motion is detected, it will shine at 800 Lumens for one minute.
Timer Switch
The timer switch works for both operation settings and controls the overall
length of time the lamp will function for.
Using a small flathead screwdriver, turn the arrow to the following settings:
0 = Dusk to Dawn operation
4,5,6,7,8 = The number of hours the lamp will operate from Dusk.
Note: When using lamp in “On” setting, the lamp will still be bright for the
first four hours and will cease operating after the total hours on the Timer
Switch has elapsed. Example: when timer is set to 6, the lamp will dim to 100
Lumens for two hours.

SurfaceMount:
Note: There are specific types of screws
for different surfaces. If you’re unsure of
the appropriate type of screw to use on
your desired surface, please consult a
professional.
page 3
Advice: ideal pole height: 6.5 – 13 feet; ideal pole diameter: 2 inches.
If multiple lights are purchased install between 25-40 feet apart for optimal light spread.
6.5 – 13 feet
25 – 40 feet 25 – 40 feet 25 – 40 feet
Assemble hardware to fixture housing as
shown in the image (make sure the curved side
of the mount faces in). Slide fixture over light
post so the curved side of the mount hugs the
light pole. Adjust the light to the desired height
and position. Then tighten the two bolts.
CAUTION: DO NOT OVERTIGHTEN SCREWS
Post Mount:
Possible places to install the 101iST60822:
• Outside Garage • House Entryway • Patios • Garden • Driveway
• Camping Site • Rural Street • Farm • Green Belts • Square
Fig. 1
Fig. 2
Diameter
1.5 - 2 in
Post
Make sure the alignment of your mounting
location is level and even for your solar light
installation. Drill two holes into your desired
installation surface using the lamp as a
template and place anchors in to the holes.
Position the two provided screws through
the holes of the lamp and into the anchors.
Tighten the screws to secure the lamp to the
surface.
*Pole not included
Solar Lamp Location
For optimum light duration throughout the night, it is very important to mount your solar lamp
in a spot where it will receive the maximum amount of direct sunlight throughout the day.

page4
ReplacingtheBatteries
After several years of use, the battery may need replacing.
1. Remove the lamp from where it is mounted and turn upside down.
2. Remove all 10 screws from the underside of the security light and remove the solar panel.
3. Unclip the battery connector and remove the old battery. Make sure the new battery is a high
quality – 1x Li-Ion Battery pack 3.7V/6,000 mAh (Item GS37V60) with matching connector.
4. Install the new battery into the battery compartment.
5. Re-assemble by reversing Steps 1-2.
Maintenance
Clean the solar panels regularly with a damp towel to guarantee
optimum performance. Do not use any type of solvent for cleaning
and be careful not to put too much pressure on the solar panels
while cleaning.
Troubleshooting
If your solar charged light does not come on at dusk despite
observance of all the instructions, please try the following steps:
1. Make sure that the solar light is not being affected by
any other light source (i.e street lights).
2. Ensure the solar light is not positioned in the shade during the day.
3. Check that the batteries are installed correctly.
NOTE: The performance of the solar lamp will vary with the time of year.
It will last longer when it has had a full day in the sun rather than a day in overcast weather.
WINTERTIME TIPS: For optimal performance, be sure to remove any snow or debris
accumulation from solar panel(s). A solar panel free of debris will charge the batteries much
more efficiently.
WARNING: Please keep out of reach of children. Do not dispose of the Li-Ion battery in the
regular trash, municipal waste stream or by fire as batteries may leak or explode. Do not open,
short circuit, or mutilate batteries as injury may occur. Preserve our environment by recycling
Li-Ion batteries or disposing of them in accordance with local, State and federal regulations. Do
not mix old and new batteries.
Please keep out of reach of children.