
P.9
清潔與保養 Care & Maintenance
1. 清潔或維修前必須先拔出電源插頭,並等
待機身冷卻。
2. 以軟布清潔機身表面的塵埃,若仍未能清除
污跡,可將軟布沾上低於50℃的酒精(混和
中性清潔劑)清潔污跡,然後待乾。
3. 請清潔設於機身背面內部的過濾網,按
解鎖鍵以拆除過濾網,然後以溫水(以低於
30℃的溫水混和一般洗衣粉)清洗。
4. 切勿以汽油、稀釋劑或任何腐蝕性物質清
潔風機表面。
5. 待風機完全冷卻及待乾,再妥為包裝後,
才可收藏,並請存放於通風處。
1. Always disconnect the fan heater from the
electrical supply by unplugging and let the fan
heater cool before repair and maintenance.
2. If there is dust on the surface of the appliance,
please clean with soft cloth. If stains remain,
dip cloth in water lower than 50℃ (mixed with
mild soap) to clean the smut and then leave it to air.
3. Please clean the filtration net placed inside the
back of the fan heater. Please press the remove
lock-key to remove the filtration net, and then
wash it with warm water (lower than 30℃, mix
with normal washing powder).
4. Do not clean the appliance with gasoline, thinner
or any materials can fret the surface of fan heater.
5. When store the appliance, please pack after the
fan heater has cooled down completely and is dry,
place the fan heater at an aerated place.
1. 按下“總電源開關”鍵後,檢查電源及插頭
是否操作正常。若蜂鳴器或顯示屏不運作,
或沒有暖風吹出,請嘗試再按下按鍵。
2. 在風機傾側、底部脫離地面或地面不平坦的
情況下,防傾斜保護掣會啟動。此時,嘗試
將風機擺放於平坦的表面,然後再次啟動。
3. 若遙控器沒有操作反應,嘗試將它對準接收
器,再次按鍵。若遙控器仍沒有反應或指示
燈沒有亮著,請更換電池。
4. 若風機處於高溫環境下,自動調溫器可能會
中斷電源以保安全。待風機冷卻後,便會繼
續操作。
5. 如上述問題持續或出現其他問題,請聯絡或
送回本公司維修部進行維修。
1. Please check whether the electrical supply and
socket work well, when you press the “MAIN POWER
SWITCH” key. If the buzzer does not work, and there
is no LCD display or hot air from the outlet, try to
press the key once again.
2. The tip-over protection switch will cut off the electric
supply, if the appliance tilts, the bottom base
deviates from the ground or the ground is not flat. In
this case, place the fan h eater at the flat place and
turn it on again.
3. If the remote control does not work well, try to adjust
the direction of holding so that the remote control
transmitter is pointed to the receiver directly.
Replace the batteries when the indicator light does
not shine or work.
4. The thermostat may cut off the power automatically
for safety, if the fan heater is used in a surrounding
with high temperature. The appliance may resume
work when the fan heater cools down.
5. If the problems persist or other problems occur,
contact our Repairs Centre for repair.
常見事故及處理 Troubleshooting