4
EnGliSH
27841 I.V. STAND 2 HOOKS
27842 I.V. STAND 4 HOOKS
27843 I.V. STAND - ALLUMINUM - 2 HOOKS
INTRODUCTION
In accord with Regulation (EU) 2017/745, this product is part of the CLASS I MEDICAL DEVICES. You
should carefully read this manual before using this medical device.
DESCRIPTION
Telescopic I.V. stand with 2/4 hooks for the support of bags and infusions. Composed of two coaxial
tubes in chromed or aluminum steel. Tubular adjustable up to 210 by plastic regulation crank. Equipped
with black plastic base with ve wheels Ø 50 mm. The device is an aid for the care of the patient who
is bedded or with limits functional autonomy.
COMPONENTS:
-n.1 tubular section 25 x 1 L.980 mm
-n.1 tubular section 20 x 1 L.1480 mm
-n.1 plastic regulation crank
-n.1 staff phlebo
-n.1 black plastic base with 5 spokes on wheels.
Assembly material
For codes 27841/27843:
-n. 1 phleboclysis case in plastic with 2 hooks (code 27845)
-n. 5 wheels Ø 50 mm
-n.1 buttery screw M6 x 30
-black cape for base
For code 27842:
-n.1 phleboclysis case in chromed steel with 4 hooks (code 27846)
-n. 5 wheels Ø 50 mm
-n.1 buttery screw M6 x 30
-black cape for base
ASSEMBLY INSTRUCTIONS:
1. Take the wheels and insert them into the base.
2. Take the tubular with a larger section (25 x 1.2) equipped with a knob, insert it rst into the black
cap, then into the base, x the parts, and screw it into the area below.
3. Take the tubular section with 20 x 1 and insert the tube inside the other until it stops using the
plastic regulation crank.
4. For 27841/27843 codes, take the plastic support with two hooks and press to insert the cap at the
end of the tubular. If necessary, use a soft hammer to insert it all completely.
5. For 27842 code, x the support with 4 hooks by castor supplied.
