Grange Dragon Pergola User manual

PKITDRGNA - 325cm [H] x 270cm [W] x 270cm [D]
DRAGON PERGOLA
CODE: PKITDRGNA
PLAN
Self-Assembly required Home Delivery available Pre-Painted available
FOOTPRINT
270cm 180cm
183cm SQ.
270cm
325cm
www.grangefen.co.uk
All products and related emblems featured
are trademarks of Grange Fencing Ltd.
©2015 Grange Fencing Ltd
All rights reserved.
In line with the Company’s policy of
continuous product development, the
right is reserved to change and improve
product design without prior notice.

ASSEMBLY INSTRUCTIONS
DRAGON PERGOLA PRESSURE TREATED GREEN
PARTS LIST
HARDWARE PACK
Posts [ATPOST9] x 4
Curved Rafters x 4
Screws - 5cm x32
[x]
Metal Brackets x 8
[z]
Tools Required: Posidrive Screwdriver
BEFORE YOU START
ASSEMBLY
•Check the pack/s and make sure that you have all of the parts listed
above. If not, contact your retailer who will be able to help you.
•When you are ready to start, make sure you have the right tools to
hand, plenty of space and a clean, dry area for assembly.
It is advisable for two people to carry out the work
SITE PREPARATION
Excavate a 30cm square hole (approx) for each
post to a depth of at least 30cm. (see Fig.1 right)
This will give your structure adequate stability.
Fig.1
30cm
B
Curved Rafters x 4
C
Rafters with upper rebate x 2
D
Rafters with lower rebate x 2
E
Ball Cap x 1
F
Centre Block x 1
G
A
To ensure longevity of your structure it is recommended that it is
treated with a wood preservative on a yearly basis.
AFTERCARE
A
Screws - 7.6cm x16
[y]
Fig.2
Fig.3
A
B
C
D
E
F G
1 Erect Posts (A). Thenslot the two Rafters (D)
intoaposition parallel to each other into the
notches in the top of the posts (see Fig.2 right).
Ensure the rebates in the rafters are facing
upwards and align with the notches of the posts.
D
E
2Then slot the two Rafters (E)across the
first rafters to form a square frame at
the top of the posts (see Fig.3 left).
Fig.4
Fig.4
Fig.5
Ensure all slots align to create
aflush surface.
3 Roof Assembly
Assemble Roof by fixing Beams (B&C)to
Centre Block (G)with 7.6cm screws (y)and
top Block with the Ball Cap (F)(seeFig.4).
Note: thelong and short
beamsmust alternate
around the block.
y
x
z
G
F
B
CB
B
C
4Secure the eight Metal Brackets (z)
with 5cm screws (x) around the top of
the frame - one on each post top - one
in the centre of each rafter ( see Fig.5 )
and secure the roof into position - long
beams (C)toward the corners.
A