GRAUPNER Udaloy Class Destroyer Admiral Panteleyev User manual

Page 1of 7
Manual
Russian Destroyer “Admiral Panteleyev”
Udaloy Class

Page 2of 7
Introduction
Service and Support
Thank you for purchasing the Graupner Udaloy Class Destroyer
named after Admiral Panteleyev. This 1:100 scale ship sets a new
standard where we have raised the bar with a new level of detail and
added functionality making it the most complete premium line ship
we have ever produced.
The Graupner Udaloy is an almost ready to run ship that requires only
a radio and battery to operate. Al the electronics such as rudder and
turrets control are already pre-installed as well as the electronics to
control the motors, lights and functional radars.
Read this manual carefully and follow the instructions to the letter
especially where the light and radar configuration and wiring is
explained.
If you experience any trouble during operation consult first the manual
before asking your dealer or Graupner Service Center for support.
Due to technical changes, the information in this manual may be
changed without prior notice. You can stay updated by visiting our
website and by subscribing to our newsletter.
To maintain this condition and to ensure safe operation, you must
read and follow this user manual and the safety notes before
using the product!
NOTE
This manual is part of that product. It contains important
information concerning operation and handling. Keep these
instructions for future reference and give it to third person in case
you transferred ownership of the product.
Graupner USA
3941 Park Dr Suite 20-571
El Dorado Hills, CA 95762
United States
[phone]
Monday to Friday – 9:00 am – 4:00 pm PST
Email: [e-mail]
www.graupnerusa.com

Page 3of 7
Contents
Technical Data
•GFK molded hull
•Structures and decks made of CNC milled plastics
•Professionally painted hull and upper deck and structures
•550 size electric motors
•Installed propeller shafts
•30A speed controller
•High torque rudder servo
•High torque turrets servos (2)
•Working navigation lights
•Working radar micro motors
•Electronic on/off controller for lights and radars
•EC3 battery cable for motor, speed controller and on/off
controller
•Boat stand (needs assembly)
•Operating manual
Most of the contents has already been installed and will not require
any assembly or tools to finish.
Length
1650mm – 65 inches
Width
300 mm – 11.81 inches
Height
640 mm – 25.20 inches
Weight
11 Kg – 24 lbs.
Scale
1:100
Radio
Minimal 5 channels
Battery
6V PB or 2S LiPo batteries
Difficulty Level
Expert
NOTE
Receiver, batteries and transmitter are not included and are
separately available from Graupner

Page 4of 7
Recommended Accessories
Safety Notes
Symbol Explanation
Part Number
Description
33016
mc-16 8 Channel Radio
768
6V 10Ah PB Battery
2386.F
Sound Switch V2
2387
Fixing Frame for Boats
GENERAL
These safety instructions are intended not only to protect the
product, but also for your own and other people’s safety. Therefore,
please read this section very carefully before using the product!
Do not leave packaging materials lying around as it may become a
dangerous toy for children.
Persons, including children, with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge, or not capable to
safely use the transmitter must not operate the transmitter without
supervision or instruction by a responsible person.
Always observe the information indicated by this warning sign.
Particularly those which are additionally marked with the CAUTION
or WARNING. The signal word WARNING indicates the potential for
serious injury, the signal word CAUTION indicates possibility of
lighter injuries.
The signal word NOTE indicates potential malfunctions.

Page 5of 7
Unpacking
Connections
The Udaloy Class Destroyer comes in a large and heavy box. If you
notice any outside damage to the box, please refuse the package
for return to our warehouse. We cannot replace or return the product
after acceptance under any condition!
NOTE
After unwrapping the protective shipping wraps and straps have
someone assist you with opening the box and lifting the model out
of the box. Do not attempt to do this by yourself as damage to the
model may occur!
Before lifting the model out of the box locate the boat stand parts on
the side of the box where it usually sits between the packaging foam
and the cardboard and assemble it.
Carefully lift the model out of the box and place it on the boat stand.
Make sure that there is plenty of clear space around the boat stand
before placing to model on it.
The model superstructure and hull are strapped together for shipping
purposes. The straps need to be removed by carefully cutting them
until all straps have been removed.
Each of the superstructures of the Udaloy can be removed for
access to the electronics. The superstructures are already wired to
the radar motors and navigation lights. A single wire with a JST
connector powers both the motors and lights and is connected to a
power wire extender with JST plugs that connects to the electrical
switching module.
NOTE
The operating voltage on the Udaloy for the radar motors and lights
is 3V. Exceeding that voltage will most likely cause damage to the
lights or motors. Always use the supplied switching module.
The Udaloy comes with a 30A waterproof ESC with a built in BEC.
The BEC can provide power to the receiver, steering servo and 2
turret servos’. If you plan to use more electronics with your receiver
or think you will be overloading the BEC with excessive use of the
servos we recommend installing a separate BEC or power source to
avoid overloading the existing BEC.
Always consult the Udaloy wiring diagram if you plan to make any
changes to your setup.

Page 6of 7
Maintenance
Environmental Protection
Warranty
The product requires regular care and maintenance. When using a
LiPo battery always make sure that you remove the battery from the
Udaloy after use and when charging.
Grease the rudder and propeller shafts regularly with a marine type
of grease product
You can clean the surfaces with a damp cloth but do not use
solvents that can potentially damage the paint.
This symbol on the product, user manual or packaging indicates that
this product must not be disposed of with other household waste at
the end of its life. It must be handed over to the applicable collection
point for the recycling of electrical and electronic equipment.
The materials are recyclable as marked. By recycling, material
reusing or other forms of scrap usage you are making an important
contribution to environmental protection.
Batteries and accumulators must be removed from the device and
disposed of at an appropriate collection point. Please inquire if
necessary from the local authority for the appropriate disposal site.
Graupner, warrants this product for a period of 24 months from the
date of purchase. The warranty applies only to the material or
operational defects already existing when you purchased the item.
Damage due to misuse, wear, overloading, incorrect accessories or
improper handling are excluded from the warranty. The legal rights
and claims are not affected by this warrantee. Please check exactly
the defects before a claim or sending in the product. Shipping the
product to Graupner is at your own expense and in case the item is
free of defects you may require paying return shipping. Graupner will
not accept any returns with a provided RMA number.
The present construction or user manual is for informational purposes
only and may be changed without prior notice. The current version
can be found on the Internet at www.graupner.com on the relevant
product page. In addition, the company Graupner has no
responsibility or liability for any errors or inaccuracies that may appear
in construction or operation manuals.

Page 7of 7