Grizzly G0704 User manual

Schlumberger-Private
Installation
Instructions for the
Grizzly G0704
WWW.HEAVYMETALCNC.COM

This kit comes with everything you see here. Plus 8 each: 5mm x
20mm stainless steel cap screws. 4 each: 4mm x 16mm stainless steel
cap screws for Z motor. 4 each: 4mm x 12mm stainless steel cap
screws for X motor. 2 each: 6mm x 75mm stainless steel cap screws
for X extension and bearing block. 2 shim washers, just in case. 2
cardboard tubes for the ball nuts. These are added just in case you
need to remove one of the ball nuts from the ball screw. Go Thomson
Linear web site for video instructions on how to safely remove the ball
nut from the ball screw.

Schlumberger-Private
Start by removing all of the handles

Schlumberger-Private
Remove the plates from both ends of the table

Schlumberger-Private
Remove the piece circled in red

Schlumberger-Private
Now the table will slide off of the saddle

Schlumberger-Private
Loosen the two set
screws and the lead
screw nut will come
off with the lead
screw

Schlumberger-Private
Move the head to the top of the column. Loosen the bolts for the head and rotate it 90 degrees. This will expose the
bolts for the lead screw nut in Z. You can also just remove the head. It will make things easier, later

Schlumberger-Private
Take off everything on top of the column

Schlumberger-Private
Also remove everything from Z handle