hager 16AX User manual

www.hager.com
Safety instructions
Electrical equipment must only be installed and assembled by a qualied
electrician in accordance with the relevant installation standards, regulations,
directives and safety and accident prevention directives of the country.
Failure to comply with these installation instructions may result in damage to
the device, re or other hazards.
Function
Mechanical light switches for electrical installations in buildings.
Correct use
- For the ush-mounted installation in standard wall boxes
(recommended wall box depth ≥ 35 mm).
- Only suitable for use in indoor areas with no drip and no spray water.
Technical data
Rated voltage: 250 V~
Frequency: 50/60 Hz
Conductor cross-section of screw terminals: max. 3 x 1.5 mm²
Distance of xing holes: 60.3 mm
Switch compliance: BS EN 60669-1, IEC 60669-1
16AX switches 1way/2way
Rated current: max. 16 AX
10AX intermediate switch
Rated current: max. 10 AX
16AX switches 1way/2way
10AX intermediate switch
Hager Dream
Installation manual

2
Information for electricians
Installation and electrical connection
DANGER!
Touching live parts can result in an electric shock.
An electric shock can lead to death.
Disconnect the connecting cables before working on the device and
cover all live parts in the area!
ç
Preparing the device for installation
(for example “16AX 2gang 1way switch”)
1Cover
Notches
Carefully loosen the cover on the notches with a at-blade screwdriver (1).
Remove the cover.
Connecting the device
L
N
CL1
NN LL
2A 1way switch
General
circuit diagram 1gang 1way
switch 2gang 1way switch
1way

3
L
LN
CC
L2 L2
L1 L1
N
L
N
CL1
L2
C
L1
L2
2way switch
General circuit diagram
1gang 2way
switch 2gang 2way
switch
2B
1gang 2way
switch
2way 2way
L
N
CL1
L1 1 1
22
L2 L2
C
L
N
Intermediate switch
General circuit diagram
Intermediate
switch
1gang 2way
switch 1gang 2way
switch
2C
2way 2way
Intermediate
Strip connection cables approx. 10 ... 12 mm.
Wire the switch according to the appropriate wiring diagram (2A or 2B or 2C).

4
Installing the device into the wall box
(for example “16AX 2gang 1way switch”)
3
After wiring, x the device with the two screws attached into the wall box (3).
Assembling the cover
(for example “16AX 2gang 1way switch”)
Cover
4
Snap the cover onto the device (4).
2-5gang frames are available for multiple combinations.