Hans Grohe Accessories C 06090 0 Series Installation guide

Installation Instructions / Warranty
Accessories C
06090xx0
Accessories C
06091xx0
Accessories C
06092xx0
Accessories C
06093xx0
Accessories C
06095xx0
Accessories C
06097xx0
06098xx0
Accessories C
06094xx0
Accessories C
06096xx0
06099xx0
Accessories E
06589xx0
Accessories E
06593xx0
Accessories E
06596xx0
Accessories S
04063xx0
Accessories E
06598xx0
06866xx0
Accessories E
06600xx0
Accessories E
06594xx0
06595xx0
Accessories E
06592xx0

2
06092xx0
Soap Dispenser
06091xx0
Soap Dish
06090xx0
Tumbler
06096xx0
Face Cloth Hook
06099xx0
Robe Hook
06093xx0
Toilet Paper Holder
06094xx0
Toilet Brush
06095xx0
Towel Ring
06097xx0
12” Towel Bar
06098xx0
24” Towel Bar
Accessories C, Accessories S
04063xx0
Toilet Paper Holder
3"
2½"
4⅛"
4½"
2½"
1⅛"
2⅞"
2½"
7⅝"
5⅛"
2½"
2½"
2⅞"
5⅛"
14⅛"
2"
2½"
7"
½"
1⅛"
1⁹⁄₁₆"
2½"
2"
11 "
⁹⁄₁₆"
13⅝"
2½"
2"
23⅝"
⁹⁄₁₆"
26⅛"
1⅝"
2⁹⁄₁₆"
2½"
2"
23⅝"
⁹⁄₁₆"
26⅛"

3
If the accessory is installed in the
shower, seal the wall around the an-
chors with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.
Installation 06092xx0, 06091xx0,
06090xx0, 06093xx0, 06094xx0,
06095xx0, 06097xx0 / 06098xx0,
04063xx0
Using the mounting piece as a template, mark the posi-
tions of the screw holes.
Drill the holes with a 6mm bit.
Do not press the mounting piece into
the accessory until the mounting piece is
screwed firmly to the wall!
Install the anchors.
Install the mounting piece with the notch at the
bottom.

4
To remove the accessory from the wall
06097 Towel bar only: Use the allen wrench to
loosen the set screw (1). Pull the accessory away from
the wall (2).
Other accessories and towel bars: Press the acces-
sory firmly over the mounting piece.
The retaining pin in the accessory will snap into place,
holding the accessory firmly on the mounting piece.
All other accessories and towel bars: Push a small tool,
such as an allen wrench, through the hole in the bottom ot the
escutcheon.
Push the tool firmly against the retaining pin (1). At the same
time, pull out on the holder (2).
06097 Towel bar only: Press the end pieces
over the mounting pieces (1). Use the enclosed allen
wrench to tighten the set screws (2)

5
If the accessory is installed in the
shower, seal the wall around the an-
chors with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.
Installation 06096xx0, 06099xx0
Drill the hole using a 6 mm bit suitable for the wall
surface.
Install the anchor.
Screw the hook to the mounting piece.
Screw the mounting piece to the wall.

6
Mark the positions of the screw holes on the wall.
Drill the screw holes using a 6 mm drill bit.
Installation 06593xx0, 06589xx0, 06592xx0, 06600xx0
If the accessory is installed in the
shower, seal the wall around the an-
chors with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.
Tumbler
06589xx0
Soap Dish
06592xx0
Soap Dispenser
06593xx0
Toilet Brush
06600xx0
Toilet Paper Holder
06596xx0
Face Cloth Hook
06594xx0
12” Towel Bar
06598xx0
24” Towel Bar
06866xx0
Robe Hook
06595xx0
Accessories E

7
Installation 06596xx0
Mark the positions of the screw holes.
Drill the screw holes using a 6 mm bit suitable for the
wall surface.
Install the anchors.
Screw the support into the anchors. The pin on the sup-
port should be on the bottom.
Slide the cover over the support. The pin on the support
clicks into place in the hole in the cover.
Place the accessory into the holder.
The accessory may be removed from the holder.
Screw the support into the anchors.
Slide the toilet paper holder over the support.
If the accessory is installed in the
shower, seal the wall around the an-
chors with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.

8
Installation 06594xx0, 06595xx0
Installation 06598xx0, 06866xx0
Mark the positions of the screw holes on the wall.
Drill the screw holes with a 6 mm drill bit
Mark the positions of the screw holes.
Drill the holes using a 6 mm drill bit.
Install the anchors.
Screw the hook into the wall.
Slide the screw cover against the wall.
If the accessory is installed in the
shower, seal the wall around the an-
chors with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.

9
Fill soap dispenser 06593xx0, 06092000
Lift the pump assembly off the bottle. Fill the bottle. Replace the
pump assembly.
Install the anchors.
If the accessory is installed in the
shower, seal the wall around the an-
chors with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.
Screw the towel bar into the anchors.
Slide the escutcheon over the screws.

10
Replacement Parts — Accessories E
1 mounting piece 96341000
2 mounting set 40915000
3 soap dish 40936000
4 tumbler 40935000
5 pump 40918000
6 bottle 40299000
7 cup 40086000
8 brush head 40088000
9 brush 40089xx0
10 holder 40215000
11 cover 96110xx0
12 mounting & support kit 40292xx0
Replacement Parts - Accessories C
xx = color
00 = chrome
62 = oil rubbed bronze
82 = brushed nickel
83 = polished nickel
12
7
8
9
11
10
2
345
6
1
2
34
5
6
7
8
9