Herman Miller Nelson Daybed User manual

HermanMiller Assembly Instructions1
How to assemble
your Daybed.
HermanMiller
Daybed Installation
Instructions
For more information about our products and services or to see a list of dealers, please visit us at
www.hermanmiller.com/product-instructions or call 888 - 443 - 4357.
© 2016 Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No. 1BFR4C - B.
4mm Allen Wrench (1)
Parts Included
Tools Required
Safety Instructions & Warning
• Read all instructions before using products
• Failure to fully tighten screws may cause injury
• Periodically check fasteners to ensure tightness
• The right is reserved to make changes at any time without notice
• Will require at least 2people
• Extra bolts have been included
Step 1
Ends
Middle
Tapping Screw (4)Short Bolt (24)
2nd Spring
15th Spring
8th & 9th
Springs
Hairpin Leg (4)
Daybed Frame (1)
Optional: Back Cushions (2)
or Side Cushion (1)
Optional: Wood Bolster (1)
OR
Seat Cushion (1)
Wood Leg (4)
Optional: Bolster
Support
Phillips Driver
With seat cushion facing upside down, lower frame onto cushion. Ensure cushion is centered
on frame then attach using three velcro straps. Straps should be secured in the positions
shown below. Weave one end of the strap in/out of the spring to limit movement.

HermanMiller Assembly Instructions2
Flip platform and cushion over so it is right side up.
Step 3
Attach wood bolster with 2 tapping screws at each support.
Step 5
Tapping Screw
Attach 2 Bolster supports with 4 Short Bolts either at back of daybed for back cushion
option, or side of daybed for side cushion option.
Step 4
Short Bolt
Attach legs using 3 Short Bolts per leg for Hairpin Legs and 4 Short Bolts per leg
for Wood Legs.
Step 2
Short Bolt
Short Bolt

HermanMiller Assembly Instructions3
Place back cushions or side cushion.
Step 6