HOMCOM 824-050V90 Installation guide

ASSEMBLY & INSTRUC
220-240V~50-60Hz 45W
TION MANUAL
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
824-050V90
0
INcjh019_ES

1
EN
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL,
OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF
AND.OTHER BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO
COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY
AND/OR PROPERTY DAMAGE!
IMPORTANT SAFETY INFORMATION
1. Read all instructions carefully before using the FAN.
2. Use this FAN only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electrical shock, or injury to persons.
3. Remove the package and ensure that the FAN is
undamaged. In case of doubt do not use FAN and contact
with your supplier.
4. Don not let children play parts of package.
5. Before use the FAN, check if the voltage marked on the
rating label corresponds to the mains in your home.
6. Extreme caution is necessary when the FAN is used by or
near children or Invalids and whenever the FAN is left
operating unattended.
7. Avoid using extension cord as the extension cord may
overheat and cause a risk of fire.
8. Do not pull the power cord to disconnect with power source.
Always grasp the plug to pull out.
9. Do not insert any objects into the FAN as it may cause an
electric shock or injure or damage to the FAN. Do not block
or tamper with the FAN in any manner while it is in
operation.
10. Do not leave the FAN unattended. Always unplug FAN when
not in use.
11. This FAN is not intended for use in wet or damp locations.

2
Never locate a FAN where it may fall into a bathtub or other
water container.
12. Do not use FAN outdoors.
13. Disconnect the fan from the mains power when not in use,
and before servicing or performing any maintenance.
14. Keep the fan clean and maintain in good condition (use an
authorized service agent).
15. Use recommended parts only (non genuine parts may be
dangerous, and will invalidate your warranty).
16. When not in use store in a safe, dry, childproof location.
17. This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
18. The back housing shall not dismantle, removal will be
dangerous .
19. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
20. Children should be supervised to ensure that they do not
play with the appliance.
WARNING :
The Main Power Switch and the On/Off
switch should not be used as the sole
means of disconnecting power. Always
unplug the power cord before servicing or
moving the unit.

3
WARNING :
To avoid danger of electric shock, unplug
from outlet when not in use and before
cleaning. If the supply cord is damaged, it
must be replaced by the manufactory or it’s
service agent or a similarity qualified
person in order to avoid a hazard.
PARTS NAME
ASSEMBLY
The base of the tower fan comes in two parts, which fit around the oscillation
base. Both parts fit easily together. The back half is the one with cut-outs for
the power supply cord.
1. First attach the front half of the base, aligning the holes in base with the
screw holes in the oscillation base, and leading the power cord through
the centre hole.
2. Then snap the back half of the base to the front half and secure with the
four screws (supplied)
3. Thread the power supply cord through the two cut-outs at the bottom of
the base.. (shown in Fig 1)

4
(Fig 1 )
REMOTE CONTROL
1.Included a button cell battery (the type of battery CR2025).
2.The Remote Control Power button is labeled as such. All the functions
performed with the Remote Control work identically to the Manual
Controls.( Fig 2)

5
( Fig 2) ( Fig 3)
OPERATION
The FAN may be operated by the manual controls located on the FAN (as
shown in Fig 3) or by your remote control (shown in Fig 2) .
1. Place the FAN on a stable flat surface. Plug the cord set into a 220-240V~
electrical outlet.Plug on the FAN, existing room temperature will be
displayed at display panel.
2. POWER : Turn the FAN on by pressing the ‘POWER’ button; Turn the
FAN off by pressing the ‘POWER’ button again.
3. SPEED : You can adjust the fan speed to the desired level: low,
medium, or high by pressing ‘SPEED’ . The speed setting is displayed on
the LED panel (shown in Fig 4).
4. MODE : Pressing the ‘MODE’ button will set the FAN into NORMAL,
NATURAL, and SLEEP mode .
- NORMAL Mode : Fan will start work at any speed you set up.

6
- NATURAL Mode :Fan will start work at low speed(5s)→medium
speed(5s)→high speed(5s)→medium speed(5s), it works as per this recycle.
- SLEEP Mode : 1) If you set the mode at high speed, fan will work at
high speed at 30 mins, then transfer to medium speed at 30 mins and
transfer to low speed until fan stop working. 2）If you set the mode at medium
speed, fan will work at medium speed at 30 mins, then transfer to low speed
until fan stop working. 3）If you set the mode at low speed, fan will work at
low speed until fan stop working. The LED Display will turn off if you don’t
control the fan in 30 seconds, touch any button to turn on the display.
5. TIMER : The fan is equipped with a timer that allows you to set it's
length of operation from 1 hour to 12 hours.The LED Display will turn off if
you don’t control the fan in 30 seconds, touch any button to turn on the
display.
6. OSC : Pressing the ‘OSC’ button will start and stop the oscillation
function. The symbol is displayed on the LED panel.
( Fig 4) ( Fig 5)
Aroma box

7
7. Display : Can be switched off temporarily by press the LED button
on the remote or by pressing and holding the SPEED button on the control
panel for more than 3 seconds, the display will light up again once any
control button is activated.
8. Aroma box:The aroma box is located at the top back side of fan, if you
want to use it, please drop some aroma into the box. (shown in Fig 5).
MAINTENANCE
1. This can only be done by an authorized service agent such as your local
Sealer dealer or any agent qualified to undertake electrical repairs.
2. If the unit requires external cleaning make sure it is switched off and
unplugged from the mains supply. Use a soft tissue or cloth for general
cleaning. To remove more persistent dirt or grime wipe down with a cloth that
has been dampened with warm soapy water. Do not use any solvents ( such
as thinners ) as these may damage the plastic casing.
DISPOSAL
WARNING!!!
Releasing refrigerant into atmosphere is strictly
forbidden!
According to European Directive 2012/19 / EU on
waste electrical and electronic equipment and
transposition into national law, used electrical
appliances must be collected separately and
recycled in an environmentally sound manner.

8
ES
LEA CUIDADOSAMENTE ANTES DE INTENTAR MONTAR, INSTALAR,
OPERAR O MANTENER EL VENTILADOR DESCRITO. PROTÉJASE YA LOS
DEMÁS OBSERVANDO TODA LA INFORMACIÓN DE SEGURIDAD. ¡INCUMPLIR
LAS INSTRUCCIONES PODRÍA PROVOCAR LESIONES PERSONALES Y / O
DAÑOS A LA PROPIEDAD!
INFORMACIÓN DE SEGURIDAD IMPORTANTE
21. Lea todas las instrucciones cuidadosamente antes de utilizar el
VENTILADOR.
22. Utilice el VENTILADOR únicamente como lo que se describe en
este manual. Cualquier otro uso no recomendado por el fabricante
puede causar incendios, descargas eléctricas o lesiones
personales.
23. Retire el embalaje y asegúrese de que el VENTILADOR no esté
dañado de ninguna manera. En caso de duda, no utilice el
VENTILADOR y póngase en contacto con su proveedor.
24. No permita que los niños jueguen con las piezas incluidas en el
paquete.
25. Antes de utilizar el VENTILADOR, compruebe si el voltaje
marcado en la etiqueta de clasificación de él corresponde a la red
eléctrica de su hogar.
26. Tenga especial cuidado cuando el VENTILADOR se utiliza por o
cerca de los niños o inválidos, y cuando se deje el
VENTILADOR en funcionamiento sin supervisión.
27. Evite utilizar un cable de extensión porque el cable de extensión
puede sobrecalentarse y causar riesgo de incendio.
28. Nunca tire del cable de alimentación directamente para
desconectarlo de la fuente de alimentación. Siempre agarre el
enchufe para sacarlo de la fuente de alimentación.
29. No inserte ningún objeto en el VENTILADOR, de lo contrario,
podría causar descarga eléctrica o lesiones o daños al
VENTILADOR. No bloquee ni estropee el VENTILADOR de

9
ninguna manera cuando esté funcionando.
30. No deje el VENTILADOR desatendido. Siempre desenchufe el
VENTILADOR cuando no esté en uso.
31. El VENTILADOR no está diseñado para ser utilizado en los
lugares mojados o húmedos. Nunca lo coloque donde se pueda
caer en una bañera u otro recipiente de agua.
32. No utilice el VENTILADOR al aire libre.
33. Desconecte el VENTILADOR de la fuente de alimentación
cuando no esté en uso y antes de realizar cualquier reparación o
mantenimiento.
34. Mantenga el ventilador limpio y en buenas condiciones (utilice el
agente de servicio autorizado).
35. Solo utilice las piezas recomendadas (las piezas no originales
pueden ser peligrosas e invalidarán su garantía).
36. Cuando el ventilador no esté en uso, guárdelo en un lugar seguro,
seco y alejado de los niños.
37. Este ventilador puede ser utilizado por los niños mayores de 8
años y las personas con capacidades físicas, sensoriales o
mentales reducidas o con falta de experiencia y conocimiento si
han recibido supervisión o instrucciones sobre el uso del
ventilador seguro y comprenden todos los peligros involucrados.
Los niños no deben jugar con el ventilador. Los niños no deben
realizar la limpieza y el mantenimiento de la parte del usuario sin
supervisión.
38. No debe desmontar la carcasa trasera del ventilador, desmontarla
será peligrosa.
39. Este ventilador no está diseñado para que lo utilicen las personas
ADVERTEN
CIA:
El interruptor de alimentación principal y el
interruptor de encendido / apagado no deben ser
utilizados como el único medio para desconectar
la alimentación. Siempre desenchufe el cable de
alimentación antes de realizar cualquier
mantenimiento o trasladar la unidad del
ventilador.