HOMCOM 824-025 User manual

ASSEMBLY INSTRUCTION
INcjh012_UK
824-025
READ AND SAVE THIS INSTRUCTION FOR FUTURE USE
824-025 220-240V~,50HZ

Important Safe Guards
When using an electrical appliance, basic safety precautions must always
be observed, including the following:
Read all Instructions before Using
WARNING: Toreducethe riskoffire,electricalshock, andinjurytoperson,the
followingmustbeadhered to:
1. This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with the
appliance.
3. The product is for household use only.
4. Connect the appliance to a single-phase AC supply voltage, specified on
the rating plate.
5. Never leave the fan un-attended while it is in use. Always turn the fan to
the “OFF” position, and unplug the fan from the electrical outlet socket,
when not in use.
6. Extreme caution is necessary when any fan is used by or near children,
invalids or elderly persons, and whenever the fan is left operating
un-attended.
7. The fan cord must not be placed under carpets, or covered with throw
rugs, runners or similar. Arrange the cord away from the traffic area, and
where it will not be tripped over.
8. Do not operate the fan with a damaged cord or plug, or after the fan
malfunctions, or has been dropped, or damaged in any manner.

9. If the supply cord is damaged, either the manufacturer, or the service
agent, or a similarly qualified person, must replace it, to avoid a hazard.
10. Use the fan in a well ventilated area. While in use, ensure that the
airtakes or exhaust openings are not blocked un-expectedly, and the fan
distance from the wall or corner must be no less than 20cm. The fan
should not be placed below or besides any curtains or similar
11. To avoid mechanical danger when in use, do not insert, or allow fingers,
or any other objects into the grill. Do not block the air-intakes or the
exhaust openings in any manner.
12. The fan must only be placed, and used on a flat dry floor.
For household use only
Structure and parts

Assembly Instructions
WARNING: Never operate the fan without its foundation and other
parts. The fan must only operate in the up-right position, and any
other position will be hazardous.
Do operate the fan only in upright position; any other position could create
a hazardous situation.
Assemble the foundation and other parts of the appliance in the following
sequence:
a). Unpack the fan and remove all parts from the package
b). Insert the tube(4) into the base’s hole(5), and tighten screw(6).
c). Put the tube into the hole of main body, and tighten screw(3).
Operating Instructions
1. Before using the fan, make sure that it is on a flat and stable surface.
Damage may occur if the fan is placed on an incline or decline.
2. Set all the switches to the “OFF” position, and then insert the plug
directly into a standard AC socket-outlet. Be sure that the plug fits tightly
into the socket-outlet.
3. Rotate “Rotary knob”on control panel to start the fan.
Rotate “Rotary knob”to 1, that mean the fan working at the low speed
Rotate “Rotary knob”to 2, that mean the fan working at the medium
speed
Rotate “Rotary knob”to 3, that mean the fan working at the high speed
Rotate “Rotary knob”to , that mean the fan working at the low
speed and oscillating at the same time.

Rotate “Rotary knob”to , that mean the fan working at the medium
speed and oscillating at the same time.
Rotate “Rotary knob”to , that mean the fan working at the high
speed and oscillating at the same time.
To stop the fan, just rotate “Rotary knob”to 0
4. This fan can be up and down oscillated by manual. The maximum
adjustable degree is 90°
5. Remove the plug from the socket-outlet to completely shut the fan off.
Cleaning / Maintenance Instructions
To safely take care of your fan, please remember to follow these
instructions below:
1. Always remove the plug from the socket-outlet, and allow the fan to stop
completely before cleaning the fan.
2. Do not allow water to drip on, or enter into the fan housing.
3. Always use a soft cloth, moistened with a mild soap solution.
4. Do not use any of the following agents as a cleaner: Gasoline, Thinners,
or Benzene.
5. In case of malfunction or doubt, do not try to repair the fan yourself, it
may result in a fire hazard or electric shock.
FAN Cleaning
Clean the fan grill, housing and base with a soft damp cloth. Do not attempt
to remove the fan blades. Please use caution around the motor housing
area. Do not allow the motor, or other electrical components to be exposed
to water.

FAN Storage
When storing your fan in the off-season, it is important to keep it in a safe
dry location. It is important to protect the fan head from any dust. We
strongly recommend using the original box, when storing the fan away.
Waste disposal
The symbol indicates that this product is not to be disposed of together
with household waste. This product must be delivered to a recycling
service or container for electrical appliances and electronic equipment.
This is done to avoid health risks and prevent harm to the environment.
Local businesses (or the environmental station in your neighborhood) are
required by law to accept and recycle such products, as a means of
environmentally sound disposal.