3/3
7.1
YOUR SPELLCASTING WITCH IS NOW
FULLY ASSEMBLED. PLUG IN AND TURN
ON TO LET THE FUN BEGIN!
OPERATION INSTRUCTIONS:
1. Plug the power adapter into a standard power outlet and adjust the settings on the Function Control
Box, located on the Torso Frame, as desired.
2. Settings:
WARNING
This item is not a toy and should be used for decoration only. This item contains small parts that can
be a choking hazard. Keep all plastic and wire parts away from children.
1. Please use the adapter supplied by manufacturer.
2. Please assemble item according to instructions. Connect all wires according to matching color.
3. Children should be supervised by adults. Item should not be grabbed, as it becomes a tipping
hazard. Keep flammables away from the adapter, as it heats up during operation.
Please view all instructions carefully before assembling. Save this instruction sheet for future
reference.
CARE AND STORAGE INSTRUCTIONS
For best performance operate your item indoors. When not in use, store this product in its original
packing. Keep away from heat and moisture.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures: Reorient or relocate
the receiving antenna, Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the
dealer or experienced radio/TV technician for help.
CAN ICES-3(B)/NMB-3(B)
IR SENSOR
Be sure nothing is
blocking the sensor.
Sensor / Détecteur
5.9 V
Try Me / Essaie-moi / Pruébame
Sensor / Détecteur
Sensor /Détecteur
This switch mode will activate lights, sound, and animation when the Infra-red
(IR) sensor is activated and will operate for 1 audio-cycle with each activation.
The Infra-red (IR) sensor has a range of up to 2 m/6.5 ft. and will activate when
someone comes within an 80-degree angle from left-to-right, as well as from
above and below.
This switch mode allows the item to be activated only if triggered by using a Step
Here Try Me Activation Pad (Not Included). The item will operate for one audio
cycle with each Try Me activation. Otherwise, the item will stay off.
This switch mode will continuously operate the lights, sound, and animation of
the item.
Raise or lower the volume using the volume control turn dial, turn all the way
down to turn the volume off .
© Seasonal Visions International
Emeryville, CA 94608
Tel: 510-428-3921
All Rights Reserved
MADE IN CHINA
