Home Styles 88 5050 20 User manual

Hardware List
C.
Side Frame
2 pcs.
B.
Stretcher
2 pcs.
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
A.
Cabinet
1 pc.
88 5050 20
End Table
Part List
D.
Shelf
1 pc.
M6x12
Head Cap Bolt
8 pcs. (+1 extra)
Hex Wrench
1 pc.
Small
Hex Wrench
1 pc.
Flat Washer
8 pcs. (+1 extra )
Spring Washer
8 pcs. (+1 extra )
Tools required for assembly : Phillips screwdriver
M4x12
Wood Screw
4 pcs. (+1 extra)
Home Styles Consumer Assistance: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319

Assembly Instructions 2/3
STEP 1
Assemble Stretchers (B),
Base (D) to Side Frame (C)
with Head Cap Bolts,
Spring Washers and Flat Washers.
(See figure 1)
STEP 2
Flat Washer
Spring Washer
Head Cap Bolt
Figure 1
IMPORTANT
* Do not tighten up all the screws until each part is properly assembled.
* You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Use a soft cloth between these parts and the floor.
B
B
C
C
D
Remove the drawer,
then place Cabinet (A)
upside down on a soft cloth.
A

Assembly Instructions 3/3
STEP 3
Attach unit onto Cabinet (A)
with Wood Screws.
Wood Screw
A
STEP 4
Turn the unit over to its’ upright position.
Remove the Pull Handle that is
installed on the inside of the drawer and
re-install it on the outside of the drawer.
(See figure 2)
Slide the drawer into position.
Figure 2