Honeywell 702 Service manual

No.702 ELECTRONIC SIREN
GENERAL INFORMATION:
FEATURES
*Siren and Driver Combined *Extreme Iy Loud Sound
*Dua I Channe I - Yelp or Steady *6 to 12 Volt DC Operation
*Attractive Appearance *Enclosed Wires for Tamper Protection
*Easi Iy Tampered *Weatherproof
The No. 702 Electronic Siren is a combination driver and speaker that emits
an extremely loud sound. Dual channel capability allows field selection of yelp
or steady sound with the steady sound having priority with both activated. The
6 to 12 volt DC operation makes the No. 702 compatible with any burglar alarm
system, fire alarm system, auto, truck or boat alarm system having 6 to 12 volt
DC output . The weatherproof, high impact plastic construction gives the unit the
flexibility of being used in interior or exterior applications without a steel
housing. The base of the No. 702 is designed to slip over a No. 19 tamper switch
offering additional protection if the installer elects to mount the unit without
a box. Should the unit be removed from the wall, the No. 19 is activated, trigger-
ing the alarm within the premises.
The unit is also available with a No. 716 cabinet.
Installation Instructions for the No. 702 are at the rear of the unit on
the decal and they are as follows:
White wire negative t-1, red wire (warble)
Yellow wire (steady)
Steady has priority.
SPECIFICATIONS:
Electrical:
Voltage:
Current Draw:
6 or’ 12 volts DC
400 milliamps, 6 volts DC
1.2 amps, 12 volts DC
Sound Output: 118 dB, 12 volts DC (for best result use filtered
power supply)
NOTE: The unit will operate on the new 1023 or 330 series controls. However,
in the latter case the sound is not as pure as if the unit were driven
by a filtered power supply.
Dimensions: 9-l/4” in length
5-3/4” in height
8” wide
lo