Honeywell ADEMCO 5804-2 User manual

N7674-3 5/99 Rev. B
ADEMCO 5804-2
WIRELESS KEY TRANSMITTER
INSTALLATION INSTRUCTIONS
GENERAL INFORMATION
The 5804-2 is a compact, 2-button
portable wireless transmitter intended
for use only with wireless alarm
systems that support 5800 series
receivers. Each button on the
transmitter may be programmed for
any zone response, but is typically used
for arming and disarming.
The 5804-2 is powered by two
replaceable lithium batteries designed to
provide up to 4 years of life. For
battery installation, see Battery
Access.
PROGRAMMING
Each 5804-2 is assigned a unique serial
number during manufacture. Each
button on the unit also has a distinct
"loop" number (refer to Figure 1) that
you must program into the control
panel during installation. Assign each
button to an individual zone and
designate the Input Type as "BR"
(Button Type RF).
When prompted for the serial number,
either press and release the button you
are programming twice, or manually
enter it through the keypad.
For complete details on how to program
the 5804-2 transmitter's serial number
at the control panel, see the control
unit's installation instructions.
Note: Buttons on this transmitter must
be pressed for at least 1/2 second to
activate the transmitter. This feature
minimizes the possibility of accidental
transmissions.
LOOP 3
LOOP 2
Figure 1: 5804-2 showing button
designations
SPECIFICATIONS
Unit Dimensions:
57mm x 38mm x 12.7mm
+ POS. end
must face down
+ POS. end
must face down

BATTERY ACCESS
Battery:
Maxell CR2025, Duracell DL 2025 or
Varta CR2025
Battery Access:
Remove case back by using the blade of
a small screwdriver to pry open. Place
batteries in case back locations (see
diagram).
+ POS END MUST FACE DOWN.
To close, snap case front and back
together.
Important Note: Do not remove
Printed Circuit Board.
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH
WHICH THIS DEVICE IS USED FOR WARRANTY INFORMATION, AND FOR DETAILS
REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE
MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
FCC ID: CFS8DL5804
ÊN7674-3OŠ
N7674-3 5/99 Rev. B
/