Horizon Fitness ANDES 5 User manual

ELLIPTICAL OWNER’S MANUAL
Read the ELLIPTICAL GUIDE before using this OWNER’S MANUAL.
ANDES 5ANDES 7i

2

3
IMPORTANT PRECAUTIONS
SAVE THESE INSTRUCTIONS
Read this ELLIPTICAL GUIDE before using the OWNER’S MANUAL. When using an electrical product, basic precautions
should always be followed, including the following: Read all instructions before using this elliptical. It is the responsibility of
the owner to ensure that all users of this elliptical are adequately informed of all warnings and precautions.

4
TO REDUCE THE RISK OF BURNS, FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS:
• If you experience any kind of pain, including but not limited to chest pains, nausea, dizziness, or shortness of breath, stop
exercising immediately and consult your physician before continuing.
• When exercising, always maintain a comfortable pace. Do not sprint above 80 RPMs on this machine. Incorrect or excessive
exercise may damage your health.
• To maintain balance, it is recommended to keep a grip on the handlebars while exercising, mounting or dismounting the machine.
• Do not turn pedal arms by hand.
• Make sure handlebars are secure before each use.
• Keep the topside of the foot support clean and dry.
• Care should be taken when mounting or dismounting the equipment. Before mounting or dismounting, move the pedal on the
mounting or dismounting side to its lowest position and bring the machine to a complete stop.
• Do not wear clothes that might catch on any part of the elliptical.
• Always wear athletic shoes while using this equipment.
• Do not jump on the elliptical.
• At no time should more than one person be on the elliptical while in operation.
• This elliptical is intended for in-home use only. Do not use this elliptical in any commercial, rental, school or institutional setting.
• Failure to comply will void the warranty.
• Do not use elliptical in any location that is not temperature controlled, such as but not limited to garages, porches, pool rooms,
bathrooms, car ports or outdoors. Failure to comply will void the warranty.
• This elliptical complies with the EN957-1/9 standard, class of elliptical: HA; braking system is adjustable.
• To prevent electrical shock, never drop or insert any object into any opening.
• Keep power cord away from heated surfaces. Do not carry this unit by it’s supply cord or use the cord as a handle.
• Disconnect all power before servicing or moving the equipment. To clean, wipe surfaces down with soap and slightly damp
cloth only; never use solvents. (See MAINTENANCE)
• Do not use other attachments that are not recommended by the manufacturer. Attachments may cause injury.
• Do not operate where aerosol (spray) products are being used or when oxygen is being administered.
• Use the elliptical only as described in the elliptical guide and owner’s manual.
• The equipment shall be installed on a stable base.
WARNING

5
At NO time should children under the age of 13 be closer to the elliptical than 10 feet.
At NO time should children under the age of 13 use the elliptical.
Children over the age of 13 or disabled persons should not use the elliptical without adult supervision.
It is essential that your elliptical is used only indoors, in a climate controlled room. If your elliptical has been exposed
to colder temperatures or high moisture climates, it is strongly recommended that the elliptical is warmed up to room
temperature before first time use. Failure to do so may cause premature electronic failure.
GROUNDING INSTRUCTIONS
If an elliptical should malfunction or breakdown, grounding provides a path of least resistance for electrical current to reduce the
risk of electrical shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug.
The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with local codes and
ordinances.
Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as to whether the product is properly grounded. Do not modify the plug provided
with the product. If it will not fit the outlet, have a proper outlet installed by a qualified electrician.
Connect this exercise product to a properly grounded outlet only.
Never operate product with a damaged cord or plug even if it is working properly. Never operate any product if it appears
damaged, or has been immersed in water. Contact your Locad Dealer for replacement or repair.
Heart rate monitoring systems may be inaccurate. Over exercise may result in series injury or death.
If you feel faint, stop training immediately.
WARNING
WARNING

6

7
ASSEMBLY
There are several areas during the assembly process that special attention must be paid. It is very important to follow the
assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed
correctly, the elliptical could have frame parts that are not tightened and will seem loose and may cause irritating noises. To
prevent damage to the elliptical, the assembly instructions must be reviewed and corrective actions should be taken.
Before proceeding, find your elliptical’s serial number located on the front stabilizer tube and enter it in the space provided
below. Also locate the model name which is next to the serial number.
ENTER YOUR SERIAL NUMBER AND MODEL NAME IN THE BOXES BELOW:
SERIAL NUMBER:
MODEL NAME:
WARNING

8
ANDES 5
SHOWN
HANDLEBAR SET CONSOLE
MAIN FRAME
POWER CORD SOCKET
STABILIZER TUBE
TRANSPORT WHEEL
ROLLER WHEEL COVER
PULSE GRIPS
BOTTLE HOLDER
CONSOLE MAST
CONSOLE MAST BOOT
PEDAL ARM
FOOTPAD
GUIDE RAIL SET

9
UNPACKING
Unpack the product where you will be using it. Place the elliptical carton on a level flat
surface. It is recommended that you place a protective covering on your floor. Never
open box when it is on its side.
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any
grease, such as lithium bike grease is recommended.
If you have questions or if there
are any missing parts, contact
your local dealer. Contact
information may be located on
the back panel of your manual or
on the warranty card.
NEED HELP?
PRE ASSEMBLY
TOOLS INCLUDED:
5 mm Allen Wrench (w/ Screw Driver)
8 mm Allen Wrench
13/15 mm Flat Wrench
PARTS BOX INCLUDED:
1 Main Frame
1 Left Handlebar
1 Right Handlebar
1 Back Console Mast Cover
1 Front Console Mast Cover
1 console Mast (with console)
1 Hardware Bag
2 Handlebar Cover
1 Owner’s Manual
1 Power Cord
ANDES 5

10
ASSEMBLY STEP 1
ASSEMBLY STEP 1
A Remove the 4 PRE-INSTALLED WASHERS (A)
and SCREWS (B) from the MAIN FRAME (2).
B Carefully pull CONSOLE CABLE from the
CONSOLE MAST (1) then attach to another
CONSOLE CALBE on the MAIN FRAME (2).
C Attach CONSOLE MAST (1) to MAIN FRAME
(2) using 4 PRE-INSTALLED WASHERS (A), 4
SCREWS (B).
1
A
B
2
ANDES 5

11
ANDES 5
ASSEMBLY STEP 2
HARDWARE FOR PACKAGE 2
PART TYPE DESCRIPTION QTY
CRING
 2
DWASHER
 4
EWASHER
 2
FSPRING WASHER  2
GSCREW
M8X1.25PX20L 2
HCOVER -- 2
A Attach HANDLEBAR SET (3) onto CONSOLE
MAST (1) using 1 RING (C), 2 WASHERS (D),
1WASEHR (E),1SPRING WASHER (F) and 1
SCREW (G), 1 COVER (H).
B Repeat step A on the other side.
C Attached CONSOLE MAST BOOT (4&5) to
MAIN FRAM (2).
3
5
CD
DEFGH
4
2
1

12
ASSEMBLY STEP 3
HARDWARE FOR PACKAGE 3
PART TYPE DESCRIPTION QTY
FSPRING WASHER  2
ISCREW
M8X1.25PX70L-12L 2
JWASHER
 2
KNUT M8X1.25P 2
A Attach the PEDAL ARM (6) onto HANDLEBAR
SET (3) with 1 SCREW (I), 1 WASHER (J), 1
SPRING WASHER (F) and 1 NUT (K).
B Repeat step A on the opposite of the elliptical.
6
K
I
F
J
3
ANDES 5

13
ANDES 5
ANDES 5
ECB Magnetic Brake System
Overall Dimension:

Folding Dimension:

Max. User Weight:
Net Weight: 78.7 kg / 174 lbs
Gross Weight: 93.7 kg / 207 lbs
ANDES 7i
Induction Brake System





Net Weight : 82.5 kg / 182 lbs
Gross Weight : 97.5 kg / 215 lbs
ASSEMBLY COMPLETE!

14
ANDES 5
ANDES 7i
FOLDING INSTRUCTION
FOLD UP INSTRUCTION
(1) To position the footpad wheel in the proper position. For ease of folding, position right or left footpad wheel located in the Ideal
Folding Area (see below picture 1).
(2) Rotate the pedal arm and place footpad wheel like picture 2 or picture 3.
(3) To grip the handle (picture 4).
(4) Pull up until guide rail set locks onto place.
HANDLE
(picture 1)
(picture 2)
(picture 3)
(picture 4)
IDEAL FOLDING AREA

15
ANDES 5
ANDES 7i
UNFOLDING INSTRUCTION
FOLD DOWN INSTRUCTION
(1) To grip the handle, push forward gently.
(2) Pull up on the handle to release.
(3) Pull back to fold down.
HANDLE

16
MOVING THE ELLIPTICAL
WARNING!
Our ellipticals are heavy, use care and additional help if necessary when moving.
Failure to follow instructions could result in injury.

17
ELLIPTICAL OPERATION
This section explains how to use your elliptical’s console and programming.
The BASIC OPERATION section in the ELLIPTICAL GUIDE has instructions for the following:
• LOCATION OF THE ELLIPTICAL
• POWER/GROUNDING INSTRUCTIONS
• FOOT POSITIONING
• MOVING THE ELLIPTICAL
• LEVELING THE ELLIPTICAL
• USING THE HEART RATE FUNCTION
• POWER/MANUAL INCLINE OPERATION

18
ANDES 5
A
B
E
I
C
H
L
M
K
F
D
G
J
Energy
Saver
Energiespar-
modus
204 8 12 16

19
ANDES 5
ANDES 5 CONSOLE OPERATION
Note: There is a thin protective sheet of clear plastic on the overlay of the console that should be removed before use.
A) LCD DISPLAY WINDOWS: Time, Distance, Speed, RPM, Resistance Level, Heart Rate, Calories, Watts, HR Wheel,
Resistance Profile, Passport Connection.
B) ENERGY SAVER: to minimize energy consumption, your machine will enter energy saver mode automatically (after
entering stand-by mode for 15 mins) and can be quickly woken up with a touch of a button.
C) ARROW BUTTONS: used up and down arrow button to select program, set up your console or change resistance
while exercising.
D) ENTER BUTTON: used to confirm setting of workout program or user profile.
E) START AND STOP BUTTON: press to begin exercising, pause your workout or resume exercising after pause. Hold
for 3 seconds to reset the console.
F) CHANGE DISPLAY / BACK BUTTON : used to scroll through display modes and workout feedbacks. Press to switch
display column and change between profile display mode for resistance(upper bar displayed) or watt profile for your
current workout watt (lower bar displayed).
also used to navigate back to the user setup progress.
G) AUDIO IN JACK: use to connect with your cellphone or MP3 to play your workout music with integrated speaker.
H) RESISTANCE DIRECT BUTTON: use the direct button to chose your desired workout resistance.
I) SPEAKER: play music through speakers when connected to your media player.
J) SMART DEVICE AND READING RACK: holds your smart phone, tablet or reading materials.
K) PASSPORT: It will on screen when connect to Passport.
L) PASSPORT QUICK KEY: used to connect to Passport. Press and sync with Passport.
M) VOLUME BUTTON: used to turn up and turn down the volume.

20
ANDES 7i A
B
E
I
C
H
L
M
K
F
D
G
J
10515 20 30
Energy
Saver
Energiespar-
modus