HUANUO HNPS02 User manual

Model: HNPS02
Thank you for choosing this HUANUO product! At HUANUO we strive to
provide you with the best quality products and services in the industry.
Should you have any issues, please don't hesitate to contact us at
Technical Support:
1-800-556-0533 Mon-Fri 8am - 8pm (CST)
Other Info:
[email protected] (US/CA)
V2.0
2 Tiers Printer Rack Instruction Manual

Supplied Parts
A X1 B X1 C X4 D X16
Wire Shelf Wooden Board Pole Plastic Clip Nylon Caster
Wrench x1
Screw nylon casters [E] into the bottom of four poles [C] by wrench.
Snap one pair of plastic clips [D] on the same groove of each pole as
shown in the below image. The arrow of all plastic clips should be point-
ed up, and the grooves of pole should be covered by convex part of
plastic clips.
Grooves of Pole Convex Part of
Plastic Clips
Step 1
D
C
E
E
X2
X2

Step 3
Step 2
Keep the collar of the wire shelf [A] downward. Then slide the wire shelf
[A] into the plastic clips from the top of each poles.
Keep the collar downward
Insert the wooden board [B] into the top of the four poles to make it snug
on the poles. Push firmly down the corners of the wire shelve [A] by
rubber mallet (not included) to make the wire shelf [A] secure onto the
plastic clips. Now the 2 tiers printer rack is completely assembled.
D A
C
B
C
D

Mallet
Towel
NOTE: Put a towel between rubber mallet and
wire shelf to prevent damage.