HUANUO HNQF2 User manual

Quad Monitor Desk Mount V1.0
HNQF2 [email protected]

1
UNPACKING INSTRUCTIONS
!Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
!Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
!Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
!Install and operate this device with care. Please read this instruction before
installation, and carefully follow all instructions contained herein. Use proper safety
equipment during installation.
!Please call a qualified installation contractor for help if you don't understand these
directions or have any doubts about the safety of the installation.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage
arising from incorrect assembly, incorrect mounting, or incorrect use of this product.
Thank you for choosing our product! We strive to provide the best
quality and services for our customers. Would you kindly share your
experience on Amazon if you are satisfied? Should you have any
issues, please don't hesitate to contact us.
Telephone：[phone] Mon-Fri 10am - 6pm (PST) (USA)
Email：[email protected] (US/CA/DE/UK/FR/IT/ES/JP/AU)

Option A: Desk Clamp Assembly
Option B: Grommet Base Assembly
1.Install the C-Clamp Brace(c) to the Pole(a)
with 3 pcs of M5x14 Bolts. Tighten the bolts
with the provided Allen Key(o). See Figure 1.
2.Install the C-Clamp(b) to the pole
assembly according to the thickness of the
desktop. The thickness can be changed to 3
positions. Connect C-Clamp(b) and C Clamp
Brace(c) by using 2 pcs of M8x12 bolts(g).
Tighten the bolts with the Allen Key(o) and
tighten the C-Clamp to the desk by
adjusting the plastic knob. See Figure 2.
1.Install the Grommet Base Plate(m) to the
Pole(a) with 3 pcs of M5x14 Bolts(f). Tighten
the bolts with the Allen Key(o). See Figure 2.
2.Position the Pole(a) on the mounting surface.
Install the spring washer(l) and M10 washer(k)
to M10 Bolt(i). Insert the bolt(i) into the Support
Plate(j) and the desk hole. Fasten the bolt(i)
with the provided Wrench(p). See Figure 3.

Option B: Grommet Base Assembly
2.Install the Grommet Base Plate(m) to the
Pole(a) with 3 pcs of M5x14 Bolts(f). Tighten
the bolts with the Allen Key(o). See Figure 5.
3.Position the Pole(a) on the mounting surface.
Install the spring washer(l) and M10 washer(k)
to M10 Bolt(i). Insert the bolt(i) into the Support
Plate(j) and the desk hole. Fasten the bolt(i)
with the provided Wrench(p). See Figure 6.