human care 1495 User manual

ASSEMBLY/USAGE TRANSFER BOARD
Models #1495
Human Care Canada Inc. All rights reserved. This manual may not be reproduced in part
or in whole without the written permission of the publisher. (REV: SEPTEMBER 2013)
OPERATING MANUAL
WARNINGS
CARE AND USE
DO NOT USE ANY PIECE IF THERE ARE ANY
CRACKS OR DAMAGED COMPONENTS
READ ALL WARNINGS CAREFULLY
KEEP THIS INFORMATION FOR FUTURE
REFERENCE
COMPONENTS
1 x Seat 4 x Footrest 4 x Screws
8 x Rubber Pads
Always fit in the teeth before
tightening while assembling
footrests.
Ensure footrest lays flat against
bathtub surface before use to
avoid possible injury.
DO NOT stand on board or drop
onto board. Your legs must
firmly touch the ground when
seated.
DO NOT exceed weight capacity!
250lb / 113.4kg
Only use on bathtub that is wide
enough to ensure stability of all
four footrests.
INCORRECT
POSITIONING
DO NOT use chlorine bleach or abrasive cleansers.
To clean, wipe down with a damp cloth using a mild
detergent only. Rinse well after use.
Supervision or assistance when using boards is
recommended for users with limited mobility.
Increase safety by using a slip resistant bath mat
in the bathtub.
Periodically check the anti-slip pads and
footrests to ensure that they are firmly in place.
Ensure your weight is evenly distributed when
sitting. Improper or uneven loading may result in
the board tipping over and/or falling.
Use only authorized parts/ accessories with
your board. SOLD SEPARATELY

ASSEMBLY/USAGE TRANSFER BOARD
Models #1495
Human Care Canada Inc. All rights reserved. This manual may not be reproduced in part
or in whole without the written permission of the publisher. (REV: SEPTEMBER 2013)
OPERATING MANUAL
ASSEMBLY
IF YOU HAVE ANY PROBLEMS OR REQUIRE
ASSISTANCE WITH THE PRODUCT PLEASE
CALL:
613-723-6734
HUMAN CARE CANADA INC.
10-155 Colonnade Road
Ottawa, ON K2E 7K1
Place anti-slip pad into the holder located on
the bottom of the transfer board and press
down until firmly in place.
Hold footrests by screwing in place from the top
of the transfer board with the plastic screw.
Fit the teeth in the footrest into the teeth on the
bottom of the board.
A red handle can be added by resting handle
into slots located on board and holding in place
by screwing in from underneath. Red handle
can be added to either or both sides.
RED HANDLE SOLD SEPARATELY
ENSURE BOARD IS LEVEL AND SECURELY IN PLACE
BEFORE USING!
DO NOT OVERTIGHTEN! This will
strip the screws and holes in the
footrest.
Fit footrest with bathtub surface at a slope.
Ensure that the footrests fit snugly against the
bathtub wall.
PAY EXTREME CAUTION ON WET
SURFACES!
Adjust footrests to bathtub size by sliding
to required distance. Once correct position
determined, tighten screws by hand.
DO NOT USE IF THERE ARE ANY CRACKED OR
DAMAGED COMPONENTS!