HUSKY LINERS 6621 Manual

6621 Front_Back.doc
04/14/03
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the
place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before
installing your new floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable.
The easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass
Plus®work well. Use of Armor All®, Son-of-a-Gun®or similar items is discouraged as these products
make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR NISSAN
FRONTIER TRUCK SECOND SEAT FLOOR LINER
DUE TO FACTORY AVAILABLE OPTIONS, YOUR FRONTIER EXTENDED CAB TRUCK LINER MAY
NEED MINOR TRIMMING TO CORRECTLY FIT YOUR TRUCK. FIRST, TEST FIT YOUR LINER. IF
YOU FIND INTERFERENCE WITH THE CONSOLE (AREA 1), PLEASE TRIM YOUR LINER AS SHOWN
ABOVE. THE TRIMMING IS EASILY DONE USING THE RECESSED GROOVE AS A TRIM GUIDE. IF
YOUR TRUCK IS EQUIPPED WITH DUAL FACTORY REAR SEATS, YOU WILL NEED TO TRIM YOUR
LINER AS SHOWN ABOVE USING THE MOLDED IN DIVIDING WALL AS A GUIDE. TO TRIM, CUT
ALONG THE RECESSED GROOVE IN THE DIVIDING WALL REMOVING THE INTERFERING
SECTION (AREA 2 ABOVE). TRIMMING PHOTOS ARE INCLUDED ON THE BACK OF THIS PAGE.
REAR OF TRUCK
1
2

6621 Front_Back.doc
04/14/03
TRIMMING PHOTOS OF PART #6621
PART #6621 SHOWN TRIMMED FOR FRONTIERS
TRUCKS WITH LONGER CONSOLE. TRIM USING
MOLDED IN GROOVE AS A GUIDE.
PART #6621 SHOWN UNTRIMMED FOR USE IN
FRONTIERS TRUCKS WITH SHORTER CONSOLE.
PART #6621 SHOWN TRIMMED FOR USE IN
FRONTIERS TRUCKS WITH TWO REAR SEATS.