iBeam TE-WPC-M User manual

800.221.0932
iBeamUSA.com
460 Walker Street, Holly Hill, FL 32117
800.221.0932
iBeamUSA.com
460 Walker Street, Holly Hill, FL 32117
TE-WPC-M
Product Manual
TE-WPC-M
Product Manual
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
Version 1.0
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
Version 1.0

1. Find a suitable location to surface mount install the camera. Make sure
the camera’s view is unobstructed and be careful not to drill into any
wires that might damage the vehicle.
2. Power and ground connections need to be made, with the red wire
going to a 12v switch source and black going to chassis ground (bare
metal).
3. Press the pair button on the monitor and camera to link.
4. When all connections have been made and before mounting the
camera, verify the camera is working and has good view of the area.
Then mount the camera down with screws.
II. Connection
II. Connection
I. Specifications
I. Specifications
+12V
GND
1. Find a suitable location to surface mount install the camera. Make sure
the camera’s view is unobstructed and be careful not to drill into any
wires that might damage the vehicle.
2. Power and ground connections need to be made, with the red wire
going to a 12v switch source and black going to chassis ground (bare
metal).
3. Press the pair button on the monitor and camera to link.
4. When all connections have been made and before mounting the
camera, verify the camera is working and has good view of the area.
Then mount the camera down with screws.
+12V
GND