Indiana Furniture One 10 Standard Top Conference Table User manual

1
One 10: Standard Top Conference Table Assembly Instructions 144” to 192” Lengths
Parts List:
Qty (2) Tops
Qty (2) Trough Assembly
Qty (4) Jointer Bolts
Qty (2) Jointer Plates
Short L-Brackets
Long L-Brackets
Hardware Included
(6) Bags of #10 x 5
8” Flat Head Screws
(2) Bag of #6 x ½” Pan Head Screws
(1) Bag of ¼”-20 x 2” Bolt and ¼”-20 Nuts
(18) Cover Caps
Tools Required
(2) People
Drill with phillips screw bit
5"
32 Allen Wrench
5mm Allen Wrench
10mm Wrench
Level
Qty (2) Bases
Qty (1) Mid Leg
2298-1102P144192 Standard Top Conference Assembly Instructions. 144" to 192"

2
Step 1: Remove the accent cover off of the bases by pulling it off.Then bolt together (1) Base and (1) Mid Leg to (1)Trough assembly using the ¼”-20 x 2” Bolt and ¼”-20 Nuts.
Next, Bolt the remaining Trough Assembly to the remaining Base Next screw on the Short L-Brackets and the Long L-Brackets using the #6 x ½” Pan Head Screws. If the table is
48” wide, using the provided Cover Caps, cover the outside holes on the base.
Base With Accent Cover
Base With Accent Cover Removed
Bolt Trough Assembly together in (4) places
and
Bolt Trough Assembly together in remaining (4) places
and
Attach L-Brackets
Place Cover Caps here
on 48” wide tables
2298-1102P144192 Standard Top Conference Assembly Instructions. 144" to 192"

3
Step 2: While keeping the outside and top surfaces flush, conenct the remaining top using the 10mm wrench and the provided Jointer Bolts. Be sure to center the Tops to the width
and the length of the trough assembly. Now, fasten the tops to the L-Brackets with the #6 x ½” Pan Head Screws. Next fasten the Jointer Plates to the Tops using #10 x 7/8” Flat
Head Screws. Note: The metal tabs go to the inside of the top where the top is routed out to accept it.
Metal Tabs go to inside of the top
Place Jointer Bolts in 1st then Fasten the Jointer Plates
Center Top with the Width of the Trough Assembly
2298-1102P144192 Standard Top Conference Assembly Instructions. 144" to 192"

4
Step 3: Fine tune adjust the worksurfaces using the adjustment set screws in the Jointer Plates with the 5"
32 Allen Wrench
Step 4: Next, level the table using the 5mm Allen wrench.
Levelers Are Here
Levelers Are Here
Fine Tune Adjustment Set Screws
2298-1102P144192 Standard Top Conference Assembly Instructions. 144" to 192"

5
Step 5: Push on Base Accent Panels from Step 1
Push Accent Panels On
2298-1102P144192 Standard Top Conference Assembly Instructions. 144" to 192"