Indiana Furniture Gleem + Ganging Bracket User manual

Gleem+ Ganging Bracket
Assembly Instructions
1
Install 2 (two) 2209-00395H3 –U Bracket, from below
along the 2 center rails.
800-422-5727
www.IndianaFurniture.com
Proper product assembly is the responsibility of the installing agent. If you have any questions concerning these instructions, please contact Customer Service.
Page 1 of 2
3Screw brackets in place using 4 (four) 2202-01078 –
#10 x 7/8 Pan Head Screw. 2 (two) screws per
bracket. NOTE: Align front of legs and bottom of
the seat rail before installing screws.
4
2
Push 2 (two) Gleem+ chairs together.
Adjust levelers as needed.

Gleem+ Ganging Bracket
Assembly Instructions
1
Attach ganging brackets as shown on Sheet 1 using
steps 2 and 3.
800-422-5727
www.IndianaFurniture.com
Proper product assembly is the responsibility of the installing agent. If you have any questions concerning these instructions, please contact Customer Service.
Page 2 of 2
3After chairs are ganged together, tighten
the screws holding the Arm Caps.
2
Loosen the screws holding the Arm Caps in
place on the ganging side of the chair.
1
Remove 2 (two) 2209-00395H3 –U Bracket.
2
Unscrew 4 (four) 2202-01078 –#10 x 7/8
Pan Head Screw. 2 (two) screws per
bracket.
3Separate Chairs.
Ganging with Arm Cap Disassembly