InFocus LP 650 Guide

LP650 Lamp Replacement Instructions
Use the chart below to interpret the LED messages.
1
Turn off the projector.
2
Unplug the power cord.
3
Allow the projector to cool for 60 minutes.
4
Remove the two screws that fasten the lamp door
to the bottom of the projector.
5
Lift the lamp door up and remove it.
6
Loosen the screw that fastens the lamp module to
the projector.
7
Remove the lamp module. Please dispose of the
module in an environmentally proper manner.
8
Install the new module in the projector. Make
sure it is fully seated.

9
Tighten the screw that fastens the lamp to the
projector.
10
Replace the lamp door and tighten the two
screws.
11
Plug the power cord in and press the Power
button.
12
Allow the projector to run for one minute.
To reset the lamp timer, press and hold down the
Volume + and Volume - buttons for ten seconds.