Ingenico group EVO Move 3500 MIX User manual

What's in the box?
Card Payment Terminal
Charging Base
Power supply unit
Ethernet Cable
PSTN Cable
Receipt Rolls
Quick Reference Guide
Window Decal
1.
2.
3.
4.
5.
6.
7.
8.
Menu - Use this button to access the main
functions menu on the terminal
Cancel - Use this button to cancel and revert
back to the previous screen
Clear - Use this button to clear back or delete
characters when keying in text/numbers
Enter - Use this button to confirm selection on
the terminal
Setup Guide
Move 3500 MIX
Function keys
7
8

Support
EVOPayments.co.uk/support-centre/
[e-mail]
Getting started
Please connect the Power Supply unit to mains power close to the desired location of the
terminal. Connect the Power supply cable to the port shown and if Using Ethernet or
PSTN, please connect the cables to the Ports shown
Once the Base and any additional cabling is connected, place the terminal in the charging
base and allow the device to power up. This will take approximately 2 minutes.
The Terminal will automatically pick-up the best mobile network available.
If using an Ethernet connection, the terminal should obtain a valid IP address and
connection automatically once connected to an Active Ethernet Port
If you wish to connect to a Wi-Fi network, please follow these steps
1. Press the yellow button, this will request an administrator password which is 123456,
and press Enter to Confirm, and enter the Administrator Menu
2. Using the up/down keys scroll down to WIFI Profile option. Press Enter to confirm.
3. Select Scan Networks and press Enter. The terminal will scan for available Networks.
4. Select the name of your network. If your router/Modem has a 2.4G and a 5G channel
select the 2.4G option.
5. Enter your WIFI password using the keypad. Confirm the password is correct and press
Enter to Continue.
6. The Wi-Fi indicator on the top of the screen will turn green
To confirm your terminal is connected and ready to accept Payments, perform a
connection test using the following steps
1 Press the Menu Button
2 Select option “Connection Test”
3 Terminal Will Print a receipt with “Connection OK” printed near the top.
4 Your terminal is now ready to use
Please consult your Quick reference guide provided for instructions on performing
transactions.