Ingenico group Move 3500 BLUETOOTH User manual

Card Payment Terminal
Charging Base
Power supply unit
Ethernet Cable
PSTN Cable
Receipt Rolls
Quick Reference Guide
Window Decal
1.
2.
3.
4.
5.
6.
7.
8.
Menu - Use this button to access the main
functions menu on the terminal
Cancel - Use this button to cancel and revert
back to the previous screen
Clear - Use this button to clear back or delete
characters when keying in text/numbers
Enter - Use this button to confirm selection on
the terminal
What's in the box?
Setup Guide
Move 3500 BLUETOOTH
Function keys
7
8

Press the Menu Button
Select option “Connection Test”
Terminal Will Print a receipt with “Connection OK” printed near the top.
Your terminal is now ready to use
Once the Base and any additional cabling is connected, place the terminal in the charging
base and allow the device to power up. This will take approximately 2 minutes.
If using an Ethernet connection, the terminal should obtain a valid IP address and
connection automatically once connected to an Active Ethernet Port. Once the Ethernet
is connective and IP address established you will see the Network and Bluetooth
Indicator at the top of the display turn green.
To confirm your terminal is connected and ready to accept Payments, perform a
connection test using the following steps:
1.
2.
3.
4.
Please consult your Quick reference guide provided for instructions on performing
transactions.
Support
EVOPayments.co.uk/support-centre/
[e-mail]
Getting started
Please connect the Power Supply unit to mains power close to the desired location of the
terminal. Connect the Power supply cable to the port shown and if Using Ethernet or
PSTN, please connect the cables to the Ports shown