Inside Weather ADA DINING CHAIR User manual

ADA DINING CHAIR / COUNTER STOOL

Gather Your Eggs...
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
Braces
Seat
Armrest
Back Legs
(Dining Chair)
Front Legs
(Dining Chair)
14x Washer Allen Key
6x 55mm Bolt8x 35mm Bolt 4x Self Tapping Wood Screw
Also Needed: Phillips Head Screwdriver (Not Included)
Back Legs
(Counter Stool)
Front Legs
(Counter Stool)

Step 1: Attach Braces
Attach the braces to the
back legs by aligning four
35mm bolts and washers to
the corresponding holes.
Attach the front legs by aligning
four 35mm bolts and washers to
the corresponding holes.

Step 2: Attach Legs
Step 3: Attach Armrests
Place the seat upside down
on a table. Use a soft surface
to protect from scratches.
Align the front and back legs
with the corresponding holes
in the seat bottom.
Attach with six 55mm bolts
and washers. Tighten to snug.
Set the wooden armrest face down.
Set the leg and seat assembly on
the armrest. (The “flat’’ side of the
armrest attaches to the legs). Position
the assembly so that the legs are
roughly centered on the armrest and
approximately 1-2 inches back from the
front of the arm.
Once you have the assembly centered
front and back and are satisfied with the
location, use a phillips head screwdriver
and the 4 self tapping wood screws to
attach the legs to the armrest.
Rear
Front

Step 5: Flip Chair Onto Legs
Flip the chair over onto
its legs. Have a seat.
DONE!
Step 4: Adjust the Feet
Adjust the feet
as needed to
level the stool.