Inside Weather SAVOY BED User manual

SAVOY BED

Gather Your Eggs...
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
Side Rails
Front Connection PlateBack Connection Plate
Back
Connection Plate
(for side table)
Front Legs
Back Legs
Support
Rail
40mm Bolt
Washer
16mm Bolt
Side Table
and Bracket
Screw Caps
Dowel
Front Rail
Back Rail
Headboard
Slats
Mega Slats
Long Hex Bit
Ratchet
Bed Bracket Bolt
Optional Parts if Side Table is included
6mm x 25 Hex Bit

Step 1: Connect Side Rails to Legs (Rear)
Place cardboard on the ground to protect
the floor and the bed frame pieces. You
can use the box it came in.
Align the left headboard leg frame with
the left side rail. Insert 8 dowels into the
corresponding holes.
With counterbore for washers facing up, fit
back left connection plate over the dowels to
align the leg and rail.
Attach plate with ten 40mm bolts and washers.
If your bed comes with the optional side table,
attach the connection plate with only six bolts
for now. The additional four bolts will be added
in a later step.

Step 2: Connect Side Rails to Legs (Front)
Align the left front leg with the
left side rail. Insert 8 dowels into
the corresponding holes.
With counterbore for washers
facing up, fit front left
connection plate over the
dowels to align the leg and rail.
Attach plate with ten 40mm bolts
and washers.

Step 3: Connect Side Rails to Legs (Front)
Step 4: Attach Back and Front Rail
Repeat steps 1 and 2 to
assemble the right side of
the frame.
Stand left side of the frame up and attach the back rail by
inserting the tabs into the corresponding slots. Insert the bed
bracket bolt and tighten with ratchet tool and 6mm hex bit.
Repeat for the right side of the frame.
Attach the front rail after the back rail has been assembled.

Step 5: Insert Table Brackets (Optional)
Insert table brackets through
the slots in the side rails.
Fasten the brackets with four
40mm bolts and washers.
Repeat for the other side.
NOTE: Optional side table will be added at a later step.

Step 6: Attach Support Rails
Insert the support rails into the front and back rails.
Angle one end into the pocket. and slide the opposite
end into the other pocket. Slide the tabs into the
corresponding slots.
Insert the bed bracket bolt and tighten with ratchet
tool and 6mm hex bit.
Repeat for the right side of the frame.
Repeat for all
support rails

Step 7: Attach Mega Slats
Step 8: Insert Slats (Left Side)
Insert the mega slats into the support rails by
inserting the tabs into the corresponding slots.
Insert the bed bracket bolt and tighten with
ratchet tool and 6mm hex bit.
Repeat for the right side of the frame.
Slide a slat into the slot
in the left side rail.
Repeat for all slats on
the left side.

Step 9: Insert Slats (Right Side)
Step 10: Attach Table (Optional)
Insert the slats for the right side by
tilting the slat and inserting it into
the corresponding slot.
Attach the side tables from
underneath using the 16mm bolts.

Step 11: Attach Headboard
Note: When fitting the peices together, make sure the connecting screws are
retracted inside their housing. Having the screw out could damage your surfaces.
Use screw caps to cover
the openings after all
are tightened.
Slide the headboard
into place and tighten
the conecting screws
through the openings

Step 12: Add Mattress
DONE!
Add a mattress (sold seperately).