Intermec PM4I User manual

Use these installation instructions to replace the power supply unit (PSU) on
the PM4i printer. The PSU kit ships with these items:
•Power supply unit (P/N 1-971131-003)
•This installation instruction sheet
To install the power supply unit, you need:
•T20 Torx screwdriver
To install the power supply unit
1Turn off the printer power and remove the power cord.
2Lay the printer on its left cover (the electronics and front cover).
PM4i
This installation procedure must only be performed by an
authorized Intermec service technician. Intermec assumes no
responsibility for personal injury or damage to the
equipment if the installation is performed by an
unauthorized person.
The electrical components in the printer are susceptible to
damage from electrostatic discharge (ESD). You must
follow standard ESD guidelines to avoid damaging the
equipment you are servicing.
Power Supply Unit Installation Instructions

3Remove the four T20 Torx screws from the bottom of the printer and then set
the printer back upright.
4Open the media cover and remove the four T20 Torx screws that attach the
electronics and front cover to the printer.
Screw
(4 places)
Screw
(4 places)

5Lift the electronics and front cover door away from the printer and carefully
disconnect the console cable from the CPU board.
6Disconnect all of the cables from the CPU board.
7Remove the four T20 Torx screws and the standoff that attach the CPU board to
the power supply unit and lift it away from the printer.
Screw
(4 places)

Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
© 2009 Intermec Technologies
Corporation. All rights reserved.
PM4i Power Supply Unit Installation Instructions
*931-067-001*
P/N 931-067-001
8Remove the six T20 Torx screws that attach the power supply unit to the printer,
disconnect the cables from it, and lift it away from the printer.
9To replace the power supply unit, reverse Steps 1 through 8. You need to reuse
the ground (GND) cable (P/N 236-068-003) and the cooling plate
(P/N 1-206170-00).
Note: When you remove the screws that attach the power supply unit to
the printer, the rear panel of the printer will detach.
Note: Make sure that you attach the GND cable through the lower left
screw when you replace the power supply unit.
Screw
(6 places)
Ground
cable