Intermec PB42 Manual

PB42 Belt Clip Instructions
The PB42 belt clip (P/N 074964) makes it easy for you to attach
the PB42 printer to your belt. The belt clip kit contains this
instruction sheet and these parts:
•Belt clip
•Belt clip base
•Torx screws (2)
To install the belt clip
1Attach the belt clip base to the back of the PB42 with the two
Torx screws.
Belt clip
base
Screw
(2 places)
2Attach the belt clip to your belt.
Belt clip

6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
©2005 Intermec Technologies
Corporation. All rights reserved.
PB42 Belt Clip Instructions
*943-047-001*
P/N 943-047-001
3Rotate the printer 90° to align the opening in the belt clip base
with the tab on the belt clip.
4Insert the printer into the belt clip and let it rotate back to its
natural vertical position.