Intermec EasyCoder 601XP User manual

1
Intermec EasyCoder 501 XP/601 XP
EasySet Bar Code Wand Setup
1. Connect the EasySet bar code wand to the
receptacle on the printer’s rear plate. 2. Readtheappropriatebarcodetosetuptheprin- ter. Hold the wand like a pencil and move it
rather swiftly across the bar code.
3. When the bar code has been accepted, the prin-
ter emits a short beep and the Ready control
lamp on the printer’s front blinks briefly.
4. This sheet only contains a selection of setup
options.Forinformationonhowtoproduceyour
own setup bar codes, please refer to the Inter-
mec Fingerprint 7.12 Reference Manual.
Serial Communication on ”uart1:”
Baudrate
1-960438-02 EasySet Bar Code Sheet for EasyCoder 501 XP/601 XP, Edition 3, September 1998
Connect here!

2
Serial Communication on ”uart1:”, cont’d.
No. of Stop Bits
RTS/CTS
ENQ/ACK
XON/XOFF, Data to Host
Reset comm. to default
Parity
Char. Length

3
Peel Off
Start- and Stopadjust Cut Off
Tear Off
Media
Contrast
XON/XOFF, Data from Host
New Line
Serial Communication on ”uart1:”, cont’d.

4
Media, cont’d.
Media Width
Media Length

5
Media, cont’d.
Print Speed
Test Labels
Media Type
Media Length, cont’d.

6
Direct Thermal Printing (Europe)
Paper Type
Direct Thermal Printing (USA)

7
Thermal Transfer Printing (Europe)
Paper Type, cont’d.

8
Thermal Transfer Printing (USA)
Paper Type, cont’d.