Intermec EasyCoder 4420 Manual

Part No. 070876-001
4420 Hinged Media Cover Instruction Sheet
The following instructions explain how to install a hinged media cover on the Intermec
4420 printer.
Parts Provided:
•Hinged media cover
•Phillips screws (2)
Tools Required:
•Phillips screwdriver
Warning
Electrical equipment can be dangerous! Make sure the printer power switch is turned
off and the AC power cord is disconnected before opening the printer media cover.
Working on live equipment can cause injury or death.
Avertissement
Le matériel électrique peut être dangereux ! Assurez-vous que l’interrupteur
d’alimentation de l’imprimante est éteint et que le cordon d’alimentation est
débranché, avant d’ouvrir le couvercle du support d’imprimante. Travailler sur du
matériel sous-tension peut provoquer des blessures ou la mort.
Installing the Hinged Media Cover
Remove the standard media cover before installing the hinged media cover.
To remove the standard media cover
1. Place the fingers of your right hand under the embossed section of the media cover
(the media cover release), and pull the bottom of the media cover away from the
base of the printer.
4420I002.eps
Feed/Pause
Power/Data
Alert
Empty/Pause
Intermec Intermec
4420
1
2
3

2. Grasp the front of the media cover with your left hand and lift the front of the media
cover upward to release it from the printer frame.
3. Lift the media cover away from the top of the printer. Discard the media cover.
4. Remove and discard the two outer screws securing the electronics cover to the
printer. Do not remove the center screw.
To install the hinged media cover
1. Fit the media cover over the printer, aligning the pilot holes on the hinges with the
pilot holes on the back cover of the printer.
2. Install the two Phillips screws (included with the hinged media cover) through the
hinges into the back cover. Allow a clearance of at least 41.91 cm (17 in) around the
printer to open and close the media cover.
Note: Adjust the media cover while tightening the screws to ensure that the front
bezel clears the label taken sensor; otherwise, the sensor may break.
Part No. 070876-001
*070876-001*
*070876-001*
6001 36th Avenue West
P.O. Box 4280
Everett, WA 98203-9280
© 2000 Intermec
All Rights Reserved
Screw
(2 places)
Hinged
cover
Front bezel Label taken
sensor
4420I001.eps