Intermec 825-192-001 User manual

Use the protective case (P/N 825-192-001) to transport and store your PB50 or PB51
printer. The protective case provides easy access to the printer buttons, connectors,
and battery, allowing you to print labels while the printer is still in the protective
case. Use the handstrap or shoulder strap accessory with the protective case to make
it easy to carry. The protective case kit contains these parts:
•Protective case accessory
•This instruction sheet
To insert the printer into the protective case
1Unzip the main flap on the protective case and insert the printer with the
control panel facing upward.
Protective Case Instructions

Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
© 2009 Intermec Technologies
Corporation. All rights reserved.
Protective Case Instructions
*943-127-002*
P/N 943-127-002
2Close the zippers on both sides of the protective case and secure the flap over
the end of the printer.
You can open the media flap to print labels while the printer is in the case. You can
also attach a power cable, a USB cable, or a serial cable to the PB50 or PB51 through
the flap which protects the communications port.
Media flap
Communications flap