International Concepts 265 User manual

ITEM
NO.
:
265
REVISED JUL 2, 2012
Printed in Vietnam
- 1 -
Description
Item No.
:
MISSION CHAIR
: 265
ASSEMBLY
INSTRUCTIONS

ITEM
NO.
:
265
REVISED JUL 2, 2012
Printed in Vietnam
- 2 -
BEFORE ASSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Chair back 1 B Seat Frame 1
C Middle
stretcher 1
D Side Stretcher
(L-R) 2
E Front Leg
(L-R) 2
F Seat 1
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM
NO.
:
265
REVISED JUL 2, 2012
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Short bolt
(M6x40mm)
3 2
Medium bolt
(M6x60mm)
4
3
Long bolt
(M6x80mm)
4 4
Flat Washer
(6.5x19mm)
11
5
Short screw
(M3.5x15mm)
2 6
Long screw
(M4x35mm)
8
7
Allen Key
(4mm)
1 8
Lock Washer
(6.5x11mm)
11
STEP 1
Attach seat frame (B) to Back (A) by using bolts (3) and (1), and washers (4) and (8).
Note: DO NOT tighten any of the bolts, until the chair is fully assembled. Put the chair on a flat level
surface, make sure the chair is level and tighten with allen key (7) as shown below.

ITEM
NO.
:
265
REVISED JUL 2, 2012
Printed in Vietnam
- 4 -
STEP 2
Attach middle stretcher (C) to side stretchers (D) with short screws (5). Tighten with a screwdriver.
STEP 3
Attach front legs (E) to the seat frame with bolts (2) and washers (4) and (8) .Tighten with allen key
(7).
Place side stretchers (D) between front and back legs, use the screwdriver to tighten the screws (6) as
shown below.

ITEM
NO.
:
265
REVISED JUL 2, 2012
Printed in Vietnam
- 5 -
STEP
4
Attach seat (F) to top of the seat frame (B) by using screws (6). Tighten with a screwdriver.